Filter
Top Products
9
English
Basic Operations
The following operations are commonly used when you play any sound source.
DVD
CD
TAPE/CDRTV SOUND VCR
FM/AM
DVD VCR TV SOUND
CD TAPE/CDR
SOURCE NAME
FM/AM
L
SPK
VOLUME
ANALOG
1
R
Current volume level is shown here
Current source name appears
Selected source name appears
LC
S.WFR
LS RS
CH-
S
LFE
SPK
PRO LOGIC DSP H.PHONE AUTO MUTING TUNED STEREO
VOLUME
BASS BOOST INPUT ATT SLEEP
DIGITAL AUTO
ANALOG
DIGITAL
LINEAR PCM
12
R
DVD Select the DVD player.
VCR Select the video component connected to the
VCR jacks.
TV SOUND Select TV sounds.
CD* Select the CD player.
TAPE/CDR* Select the cassette deck (or the CD recorder).
FM/AM* Select an FM or AM broadcast.
• Each time you press the button, the band
alternates between FM and AM.
Notes:
• When connecting a CD recorder (to the TAPE/CDR jacks), change
the source name shown on the display. For details, see page 12.
• When you press one of the source selecting buttons on the remote
control marked above with an asterisk (
*
), the receiver
automatically turns on.
Signal and speaker indicators on the display
The signal indicators light up in the following cases:
• Only the indicators for the incoming signals light up.
• When analog input is selected, “L” and “R” always light up.
The speaker indicators light up only —:
• When the corresponding speaker is activated.
AND
• When the corresponding speaker is required for the DSP mode
selected currently.
L:•When digital input is selected: Lights up when the left
channel signal comes in.
• When analog input is selected: Always lights up.
R:•When digital input is selected: Lights up when the right
channel signal comes in.
• When analog input is selected: Always lights up.
C: Lights up when the center channel signal comes in.
LS: Lights up when the left rear channel signal comes in.
RS: Lights up when the right rear channel signal comes in.
S: Lights up when the monaural rear channel signal comes in.
LFE:Lights up when the LFE channel signal comes in.
Note:
When “SUBWOOFER” is set to “YES,”
S.WFR
lights up.
Signal indicators light up in
red:
Speaker indicators light up
in white:
S.WFR
LS RSS
LFE
RCL
S.WFR
LS RSS
LFE
RCL
STANDBY
POWER
Turning the Power On and Off (Standby)
On the front panel:
To turn on the power, press POWER.
The STANDBY lamp goes off. The name of
the current source (or station frequency)
appears on the display.
To turn off the power (into standby mode),
press POWER again.
The STANDBY lamp lights up. A small
amount of power is consumed in standby
mode. To turn the power off completely,
unplug the AC power cord.
From the remote control:
To turn on the power, press AUDIO
POWER.
The STANDBY lamp goes off. The name of
the current source (or station frequency)
appears on the display.
To turn off the power (into standby mode), press AUDIO POWER
again. The STANDBY lamp lights up.
Selecting the Source to Play
Press one of the source selecting buttons.
On the front panel:
From the remote control:
STANDBY
POWER
AUDIO
POWER
EN09_18.RX-6510VBK[C]_f 01.2.5, 4:25 PM9