JVC RX-530RBK Stereo Receiver User Manual


 
English
Page 34
Troubleshooting
Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact
your JVC service center.
SOLUTION
Plug the power cord into an AC outlet
and press POWER to set it in the
_ON position
Check speaker wiring and
reconnect if necessary
Press SPEAKERS 1 and 2 correctly
Select the correct source
Check speaker wiring and reconnect if
necessary
Adjust the balance properly (see page
13)
Connect an outside FM antenna or
contact your dealer
Select a new station
Check with your dealer to be sure you
have the correct antenna
Check connections
Move the antenna farther from
automobile traffic
Move speakers away from the turntable
Remove the obstruction
Replace batteries
PROBLEM
The display does not light up
No sound from speakers
Sound from one speaker only
Continuous hiss or buzzing
during FM reception
Occasional cracking noise
during FM reception
Howling during record
playing
Remote control does not
work
POSSIBLE CAUSE
The power cord is not plugged in
or the POWER switch is
pressed to set in the OFF position
Speaker signal cables are not
connected
The SPEAKERS 1 and 2 are not
set correctly
An incorrect source is selected
Speaker signal cables are not
connected properly
The balance is set to one extreme
Incoming signal is too weak
The station is too far away
An incorrect antenna is used
Antennas are not connected
properly
Ignition noise from automobiles
Your turntable is too close to
speakers
There is an obstruction in front of
the remote sensor on the receiver
Batteries are weak
RX-530RBK(EF)_0021-001A_En 97.4.24, 0:31 PM34