Filter
Top Products
English
Page 14
When the shut-off time comes, the receiver turns off (into standby mode) automatically.
To check or change the time remaining until the shut-off time:
1. Press SETTING if necessary, so that the Control % / fi / @ / # buttons work for setting the Sleep Timer.
2. Press Control % / fi if necessary, until “<SLEEP>” appears on the display.
3. Press Control @ / #.
The remaining time until the shut-off time appears in minutes.
• To change the shut-off time, press Control @ / # repeatedly.
To cancel the Sleep Timer, press Control @ / # repeatedly in step 3 above until “0” appears on the display.
(The SLEEP indicator goes off.)
Turning off the power (into standby mode) also cancels the Sleep Timer.
Selecting the Center Speaker Size
You can register the information about the center speaker after all connections are completed.
If you do this registration first, you do not have to adjust the center speaker mode when you want to activate
the surround sound.
However, to register the information, first you have to set the surround mode either to “PROLOGIC” or
“3CHLOGIC.” (You cannot select the center speaker size when the surround mode is “OFF” or “HALL.”)
On the front panel only:
1. Press SURROUND so that the Control
%%
%%
% /
fifi
fifi
fi buttons work for selecting the surround mode.
The lamp above the button lights up.
2. Press Control
%%
%%
% /
fifi
fifi
fi until “PROLOGIC” or “3CHLOGIC” appears on the display.
The indicator of the selected mode also lights up on the display.
3. Press SETTING so that the Control
%%
%%
% /
fifi
fifi
fi /
@@
@@
@ /
##
##
# buttons work for selecting the center speaker
size.
The lamp above the button lights up.
4. Press Control
%%
%%
% /
fifi
fifi
fi until “CNTR SPK” (Center Speaker) appears on the display.
5. Press Control
@@
@@
@ /
##
##
# to select the appropriate item about your center speaker.
Each time you press the button, the display changes to show the following:
LARGE Select this mode when the size of the center speaker is the same as that of the front speakers.
SMALL Select this mode when the size of the center speaker is smaller than that of the front speakers.
NO Select this mode when you do not use a center speaker.
(This mode cannot be selected when you select “3CHLOGIC.”)
Note:
This “center speaker size” setting is so related to the center mode setting for the Dolby Surround that
changing this setting affects and changes the center mode to a relevant mode, and vice versa.
For example;
• If you select “LARGE,” the center mode is automatically set to “WIDE,” and vice versa.
• If you select “SMALL,” the center mode is automatically set to “NORMAL,” and vice versa.
• If you select “NO,” the center mode is automatically set to “PHANTOM” for PRO LOGIC, and vice versa.
SETTING
NO
LARGE SMALL
SURROUND
SETTING
RX-430VBK(EF)_0022-001A_En 97.4.24, 1:56 PM14