JVC RX-6012RSL Stereo Receiver User Manual


 
10
Adjusting the Subwoofer Output Level
You can adjust the subwoofer output level if you have selected
“YES” for the “SUBWOOFER” (see page 11).
Once it has been adjusted, the receiver memorizes the adjustment.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
When the front speakers are deactivated, the subwoofer level
cannot be adjusted.
On the front panel:
1. Press ADJUST repeatedly until
“SUBWFR LEVEL” appears on
the display.
The display changes to show the current setting.
2. Press CONTROL UP 5/DOWN
to adjust the subwoofer output
level (+10 dB to –10 dB).
From the remote control:
1. Press SOUND.
The 10 keys are activated for sound adjustments.
2. Press SUBWOOFER +/– to adjust
the subwoofer output level (+10 dB
to –10 dB).
Attenuating the Input Signal
When the input level of the playing source is too high, the sounds
will be distorted. If this happens, you need to attenuate the input
signal level to prevent the sound distortion.
Once it has been adjusted, the receiver memorizes the adjustment.
On the front panel ONLY:
Press and hold INPUT ATT so that
the INPUT ATT indicator lights up
on the display.
Each time you press and hold the button, the
Input Attenuator mode turns on (“INPUT ATT
ON”) or off (“INPUT NORMAL”).
ADJUST SETTIN
L
S.WFR
SPK
ANALOG
R
L
S.WFR
SPK
ANALOG
R
CONTROL
DOWN UP
SOUND
32
– SUBWOOFER +
INPUT ANALOG
INPUT ATT
L
SPK INPUT ATT
ANALOG
R
L
SPK
ANALOG
R
CONTROL
DOWN UP
ADJUST SETTI
N
L
SPK
ANALOG
R
or
L
SPK
ANALOG
R
Notes:
This function is available only for the sources connected using the
analog terminals.
This function does not take effect when digital input is selected.
Adjusting the Tone
You can adjust the bass and treble sounds as you like.
Once it has been adjusted, the receiver memorizes the adjustment.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press ADJUST repeatedly until
“BASS” or “TREBLE” appears on
the display.
Select “BASS” to adjust the bass sound level.
Select “TREBLE” to adjust the treble sound level.
2. Press CONTROL UP 5/DOWN
to adjust the bass or treble sound
level (+10 dB to –10 dB).
Each time you press the button, the sound
level changes by ± 2 steps.
EN08-20.RX-6010&6012R[B]_f 01.1.9, 6:39 PM10