Filter
Top Products
7
English
Getting Started
CAUTION:
If you connect a sound-enhancing
device such as a graphic equalizer
between the source components
and this receiver, the sound output
through this receiver may be
distorted.
Connecting Audio/Video Components
You can connect the following components to the receiver using cables with RCA pin
plugs.
Audio Components Video Components
• Turntable • TV
• CD player • VCR
• Cassette deck • DVD player
To video input (see note to the right)
To audio/video output
To audio output
To audio/video input
VCR
TV
Video component connections
TV and VCR connection
If your audio components have a COMPU LINK-3 terminal
The COMPU LINK remote control system allows you to control other JVC audio
components from the receiver or vice versa.
For detailed information about the COMPU LINK-3 remote control system, see page
36.
To audio
output
Turntable
To audio output
CD player
Cassette deck
To audio input
To audio output
If a ground cable is provided
for your turntable, connect the
cable to the GND terminal of
the AM LOOP terminals on the
rear panel.
Audio component connections
Notes:
• Any turntables incorporating a
small-output cartridge such as
an MC (moving-coil type) must
be connected to the receiver
through a commercial head
amplifier or step-up transformer.
Direct connection may result in
unsufficient volume.
• When connecting an audio/
video component (ex.: Video
CD player) with "karaoke” —
singing along — function, use
the audio signal attenuating
cord supplied with this
receiver. If not, sound may be
distorted.
TAPE
PHONO
CD
OUT
(REC)
IN
(PLAY)
VCR
OUT
(REC)
IN
(PLAY)
OUT
(REC)
IN
(PLAY)
MONITOR
OUT
L
R
TV
SOUND
DVD
LEFT
RIGHT
VIDEO
LEFT
RIGHT
DVD
FRONT
CENTER
SUBWOOFER
L
R
REAR
AUDIO
ANTENNA
AM
EXT
GND
FM
75
GND
AM
LOOP
FM
TAPE
PHONO
CD
OUT
(REC)
IN
(PLAY)
VCR
OUT
(REC)
IN
(PLAY)
OUT
(REC)
IN
(PLAY)
MONITOR
OUT
L
R
TV
SOUND
DVD
LEFT
RIGHT
VIDEO
LEFT
RIGHT
DVD
FRONT
CENTER
SUBWOOFER
L
R
REAR
AUDIO
VHS
Note:
When connecting a JVC TV:
–
If you use the AV COMPU LINK
remote control system to
operate the TV, connect the
receiver to the Video Input 2
jack on the TV.
–
If you do not use the AV
COMPU LINK remote control
system to operate the TV,
connect the receiver to the
Video Input 1 jack on the TV.
EN01-19.RX-60VGD[UF]/F 98.8.27, 5:15 PM7