Filter
Top Products
18
NOTE
• Always set volume to the minimum level when connecting or disconnecting the other equipment.
To playback sounds on the PC
Refer to the manuals supplied with the media player application installed on the PC.
* Microsoft
®
, Windows
®
98SE, Windows
®
Me, Windows
®
2000 and Windows
®
XP are
registered trademarks of Microsoft corporation.
NOTES
• You cannot send any signal or data to your PC from this System.
• DO NOT turn off the unit or disconnect the USB cable while installing the drivers and for several
seconds while your PC is recognizing the receiver.
• Use a full speed USB cable (version 1.1).
Recommended cord length is shorter than approximately 2 m.
• If your PC does not recognize the unit, disconnect the USB cable and connect it again. If it does
not work yet, restart Windows.
• The installed drivers can be recognized only when the USB cable is connected between the unit
and your PC.
• The sound may not be played back correctly— interrupted or degraded—due to your PC settings
and PC specifications.
3
Connect the System to the PC using a USB cable (not supplied).
• Use “USB series A plug to B plug” cable.
4
The USB drivers are installed automatically.
(rear panel)
USB cable
(not supplied)
PC
NX-PS1[C].BOOK Page 18 Tuesday, October 31, 2006 5:46 PM