Filter
Top Products
20
English
Using the Cassette Deck
(Recording)
PLAY & EXCHANGE SYSTEM
DISC
DISC
DISC
DISC
3
TRIPLE TRAY
COMPACT
DIGITAL AUDIO
REPEAT
RANDOM
CONTINUE
SOUND
MODE
ACTIVE
BASS EX.
MULTI CONTROL
VOLUME
EJECT
STANDBY
SENSOR
P. UPP. DOWN
TUNING
UP
TUNING
DOWN
CD REC STARTDUBBING
START/STOP
REC
DECK A/B REVERSE MODE
PHONES
CD
TAPE
AUX
FM
/AM
EJECT
PLAY REC/PLAY
AB
AUTO REVERSE AUTO REVERSE
FULL-LOGIC CONTROL
AUTO TAPE SELECTOR
MIC 1 MIC 2 MIC LEVEL
POWER
MIN MAX
CD REC START
REC START/STOP
DUBBING
1
23
456
7
8
9
ACTIVE
BASS EX.
REC PAUSE
10
10
FM/AM
A
B
DISC
FM MODE
PLAY MODE
7
/CLEAR
£/8
DISC
DISC
VOLUME
SHIFT
SOUND
MODE
SLEEP
ECHO
POWER
RM-SED50TXU
REMOTE CONTROL
AUX
C D
DECK
CLOCK TIMER
SET
– SELECT +
REC PAUSE
Recording onto a cassette from any of the sound sources is simple. Just place a tape in Deck B, have the
source ready, make one or two settings, and you’re ready to record. For each source the procedure is a
little bit different and now we’ll explain just what to do for each one. If you forget, just come back to the
section which has the specific procedures you need. But first, here are a few things to make your record-
ings better.
Things To Know Before You Start Recording ———————
o It may be unlawful to record or play back copyrighted material without the consent of
the copyright owner.
o When you want to record onto both sides of a tape, you can set Reverse mode on to do so. However,
recording automatically stops after recording in the 2 direction in Reverse mode. Therefore, make
sure that the tape direction is 3 when recording with Reverse mode on.
o The recording level, which is the volume at which the new tape is being made, is automatically set
correctly, so it is not affected by the VOLUME control on the System. Thus, during recording you can
adjust the sound you are actually listening to without affecting the recording level.
o Two small tabs on the back of the cassette tape, one for side A and one for side B, can be removed to
prevent accidental erasure or re-recording. To record on a cassette with the tabs removed, you must
cover the holes with adhesive tape first.
However, when a type II tape is used, only cover part of the hole as shown, since the other part of the
hole is used to detect the tape type.
o When recording, you can hear Sound Mode effects through the speakers or headphones. However, the
sound is recorded without Sound Mode effects.
o Type I and Type II tapes can be used for recording.
Display
A.BASS EX
kHz
MHz
CONT.
ALL PRGM
REC
S.MODE
SLEEP MONO
STCLOCK
RANDOM
REC indicator
When the System is being used, the display shows other items as well.
However, we have only shown the items described in this section.
CA-D301/401/501T[U]/EN 97.7.15, 6:08 PM20