JVC MX-D302T Stereo System User Manual


 
23
Using the Timer
The timers let you control listening and recording functions automatically.
Use the Remote Control to set the clock and timers.
Setting the Clock
The timers depend on the clock: the clock must be right for the timers to work as you expect.
You can set the clock whether the Unit is on or off.
Note that the clock must be set, otherwise the timers cannot be set.
1. Press the SHIFT button.
2. Press the 1 CLOCK button.
The CLOCK indicator on the display lights up and the clock time blinks.
3. Press the SELECT 5 + or 4 – button to set the time.
Pressing the 5 + button increases the time and pressing 4 – decreases the time. Pressing the button
continuously advances or decreases the time in 10 minute intervals.
4. Press the 8 SET button.
The clock stops blinking, and the clock timer starts from 0 seconds.
CAUTION: If there is a power failure, the clock loses its setting. The
display shows “AM12:00”, and the clock must be reset.
When the System is being used, the display shows other items as well.
However, we have only shown the items described in this section.
1
23
456
7
8
9
ACTIVE
BASS EX.
REC PAUSE
10
10
FM/AM
A
B
DISC
FM MODE
PLAY MODE
7
/CLEAR
£/8
DISC
DISC
VOLUME
SHIFT
SOUND
MODE
SLEEP
POWER
RM-SE40TU
REMOTE CONTROL
AUX
C D
DECK
CLOCK TIMER
SET
– SELECT +
kHz
MHz
CONT.
ALL PRGM
REC
A.BASS EX S.MODE
SLEEP MONO
STCLOCK
RANDOM
1 CLOCK
2 TIMER
4 – SELECT 5 +
8 SET
SHIFT
Timer indicator
Clock, timer-on time etc.
Display
SHIFT
1
CLOCK
45
– SELECT +
8
SET
EN.MX-D302T[J]/ff 98.1.16, 4:11 PM23