Filter
Top Products
44
7 Handling Discs
• Remove the disc from its case by holding it at
the edge while pressing the center hole lightly.
• Do not touch the shiny surface of the disc or
bend the disc.
• Put the disc back in its case after use to
prevent warping.
• Be careful not to scratch the surface of the disc
when placing it back in its case.
• Avoid exposure to direct sunlight, extreme
temperature and moisture.
To clean the disc
Wipe the disc with a soft cloth in a straight line
from center to edge.
• DO NOT use any solvent — such as
conventional record cleaner, spray,
thinner or benzine — to clean the disc.
7 Cleaning the system
• Stains on the system should be wiped off with a soft cloth. If the
system is heavily stained, wipe it with a cloth soaked in water-
diluted neutral detergent and wrung well, then wipe clean with a
dry cloth.
• Since the system may deteriorate in quality, become damaged or
get its paint peeled off, be careful about the following.
–DO NOT wipe it with a hard cloth.
–DO NOT wipe it forcefully.
–DO NOT wipe it with thinner or benzine.
–DO NOT apply any volatile substance such as insecticides to it.
–DO NOT allow any rubber or plastic to remain in contact with
it for a long time.
If there are any other cases than the noted above or if this system does not seem to work properly, turn off the system and turn it back on.
Maintenance
Troubleshooting
PROBLEM POSSIBLE CAUSE SOLUTION
Power does not come on. The power cord and/or system cord is not connected. Connect the power cord and system cord correctly. (See
pages 14 and 15.)
The remote control does
not work.
The batteries are exhausted. Replace the batteries. (See page 7.)
Sunlight is shining directly on the remote sensor. Hide the remote sensor from direct sunlight.
No sound. The system cord and/or speaker cord is not connected. Check the connection.
The audio cord is not connected to AUX IN (VCR),
TAPE IN (only for TH-C90) and/or DIGITAL IN (DBS)
correctly.
Connect the cord correctly. (See page 14.)
An incorrect source has been selected. Select the correct source. (See page 19.)
No picture is displayed
on the TV screen.
The video cord is not connected correctly. Connect the cord correctly. (See page 13.)
The disc or file is not playable. Use a playable disc or file. (See pages 3 and 4.)
No picture is displayed
on the TV screen, the
picture is blurred, or the
picture is divided into
two parts.
The scan mode is set to the progressive mode
(“NT. 480P” or “PAL. 576P”) though the center unit is
connected to the TV which does not support the
progressive video input such as a conventional TV.
Change the scan mode to the interlace mode
(“NT. 480I” or “PAL. 576I”). (See page 20.)
Video and audio are
distorted.
The disc is scratched or dirty. Replace or clean the disc.
A VCR is connected between the center unit and the
TV.
Connect the center unit and TV directly. (See page 13.)
The picture does not fit
the TV screen.
The monitor type is not set correctly. Set “MONITOR TYPE” properly. (See page 38.)
The broadcast is hard to
hear because of noise.
Antennas are disconnected. Reconnect the antennas correctly and securely. (See
page 8.)
References
EN_TH-C906020[USUGUX].book Page 44 Thursday, June 29, 2006 5:30 PM