Filter
Top Products
36
To change the transmittable signals for
operating another manufacturer’s DVD player
1 Press and hold STANDBY/ON DVD.
2 Press DVD.
3 Enter a manufacturer’s code using buttons 1 – 9,
and 0.
Manufacturer Codes
JVC 01*
Panasonic 02
Philips 04
Pioneer 03
Sony 05
Toshiba 06
Yamaha 07
* “01” is the initial setting.
4 Release STANDBY/ON DVD.
Now you can perform the following operations on the DVD
player:
STANDBY/ON DVD: Turn on and off the DVD player.
After pressing DVD or DVD MULTI, you can perform the
following operations on the DVD player:
3: Start playing.
4: Return to the beginning of the current (or previous)
chapter (or fast reverse for some models).
¢: Skip to the beginning of the next chapter (or fast
forward for some models).
7: Stop playing.
8: Pause playing. To resume, press 3.
After pressing DVD (or DVD
MULTI), these buttons can be used
for the DVD menu operations.
Note:
For detailed menu operations, refer to
the instructions supplied with the discs
or the DVD player.
5 Try to operate your DVD player by pressing
STANDBY/ON
DVD.
When your DVD player turns on or off, you have entered the
correct code.
To change the transmittable signals for
operating another manufacturer’s VCR
1 Press and hold STANDBY/ON VCR.
2 Press VCR.
3 Enter a manufacturer’s code using buttons 1 – 9,
and 0.
Manufacturer Codes
JVC 01*, 02, 03
Emerson 10, 22
Gold Star 11
Hitachi 04
Mitsubishi 12
NEC 21
Panasonic 07, 13
Philips 09
RCA 05, 06
Samsung 20
Sanyo 17, 18, 19
Sony 14, 15, 16
Zenith 08
* “01” is the initial setting.
4 Release STANDBY/ON VCR.
Now you can perform the following operations on the VCR:
STANDBY/ON
VCR: Turn on and off the VCR.
VCR CH +/–: Change the TV channels on the
VCR.
After pressing VCR, you can perform the following operations
on the VCR:
3: Start playing.
REW: Rewind the tape.
FF: Fast-forward the tape.
7: Stop playing or recording.
8: Pause playing. To resume, press 3.
REC PAUSE: Enter recording pause.
To start recording, press this button then 3.
5 Try to operate your VCR by pressing
STANDBY/ON
VCR.
When your VCR turns on or off, you have entered the correct
code.
If there are more than one code listed for your brand of
VCR, try each one until the correct one is entered.
MENU
ENTER
4
7/P
10
2
8
6
Manufacturers’ codes are subject to change without notice.
If they are changed, this remote control cannot operate the
equipment.
Operating Other Manufacturers’ Video Equipment (Only for RX-6042S)
31-38_5042&6042[A]2.p65 04.3.26, 6:34 PM36