Filter
Top Products
26
English
One Touch Operation
This receiver can memorize the optimum sound settings for each playing source.
About the One Touch Operation
JVC’s One Touch Operation function is used to assign and store different sound settings
for each different playing source. By using this function, you don’t have to change the
settings every time you change the source. The stored settings for the newly selected
source are automatically recalled.
The following can be stored for each source:
• Volume level (see page 21)
• Balance (see page 23)
• Loudness (see page 23)
• SEA modes (see page 31)
• DSP modes
– 3D-PHONIC mode settings (see page 34)
– DAP mode settings (see page 36)
– Surround mode settings (see page 39)
• DVD MULTI playback mode settings (see page 44)
Using the One Touch Operation
On the front panel
only
:
To store the sound settings
1. Press ONE TOUCH OPERATION.
The ONE TOUCH OPERATION lamp lights up, then
the previously memorized settings are recalled.
2. Adjust the sound using the functions listed above.
The newly adjusted settings are memorized.
To recall the sound settings
With the ONE TOUCH OPERATION lamp lit, the settings
for the currently selected source is recalled, when the
source is selected.
To cancel the One Touch Operation function
Press ONE TOUCH OPERATION so that the lamp goes
off.
(Even though the One Touch Operation function is
canceled, the recalled sound effects remain active.)
Notes:
• If the source is FM or AM, you
can assign a different setting
for each band.
• The DSP modes and DVD
MULTI playback mode cannot
be used at the same time.
ONE TOUCH OPERATION
ONE TOUCH OPERATION
EN20_46.RX-774P[U]/1 98.3.10, 2:50 PM26