Filter
Top Products
8
ENGLISH
Storing stations in memory
You can use one of the following two methods to
store broadcasting stations in memory.
• Automatic preset of FM stations: SSM (Strong-
station Sequential Memory)
• Manual preset of both FM and AM stations
FM station automatic preset: SSM
You can preset 6 local FM stations in each FM band
(FM1, FM2 and FM3).
1
Select the FM band (FM1 – 3) you want
to store FM stations into.
Each time you press the
button, the FM band
changes as follows:
2
Press and hold both buttons for more
than 2 seconds.
Local FM stations with the strongest signals are
searched and stored automatically in the band
number you have selected (FM1, FM2 or FM3).
These stations are preset in the number buttons —
No.1 (lowest frequency) to No.6 (highest frequency).
When automatic preset is over, the station stored
in number button 1 will be automatically tuned into.
3
Tune into a station you want while
“MANU” is flashing.
• If you release your finger from the button,
the manual mode will automatically turn off
after 5 seconds.
• If you hold down the button, the frequency
keeps changing (in 50 kHz intervals
(87.5 MHz – 108 MHz), in 30 kHz intervals
(65 MHz – 74 MHz) for FM and 9 kHz intervals
for AM – MW/LW) until you release the button.
When an FM stereo broadcast is hard to
receive:
Press MO RND (monaural/random) while
listening to an FM stereo broadcast.
• Each time you press the button, the MO
indicator lights up and goes off alternately.
When the MO indicator is lit on the display, the
sound you hear becomes monaural but the
reception will be improved (the ST indicator
goes off).
“SSM” appears, then disappears when automatic
preset is over.
F1 F2 F3 AM
(FM1) (FM2) (FM3)
Press 4 to tune
into stations of lower
frequencies.
Press ¢ to tune
into stations of higher
frequencies.
Lights up when receiving
an FM broadcast in stereo.
MO
EN07-09.KS-FX915R/815[EE]/f 00.12.12, 7:01 PM8