Filter
Top Products
13
ENGLISH
Other convenient RDS functions
and adjustments
Changing the display mode while
listening to an FM station
You can change the initial indication on the
display to station name (PS NAME), station
frequency (FREQ) or clock time (CLOCK), while
listening to an FM RDS station.
• See also “Changing the general settings
(PSM)” on page 19.
1 Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.
2 Press 4 / ¢ (for KS-FX473R/KS-
FX470R) or / (for KS-F363R/KS-F360R)
to select “DISPMODE” (display mode).
3 Press + or – to set to the desired indication
(“PS NAME,” “FREQ” or “CLOCK”).
4 Press SEL (select) to finish the setting.
Note:
By pressing DISP, you can also change the display
while listening to an FM RDS station.
Each time you press the button, the following
information appears on the display:
• Then, the display goes back to the original
indication in several seconds.
Setting the TA volume level
You can preset the volume level for TA Standby
Reception. When a traffic programme is received,
the volume level automatically changes to the
preset level.
• See also “Changing the general settings
(PSM)” on page 19.
1 Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.
2 Press 4 / ¢ (for KS-FX473R/KS-
FX470R) or / (for KS-F363R/KS-F360R)
to select “TA VOL.”
3 Press + or – to set to the desired volume.
You can set it from “VOL 00” to “VOL 50.”
4 Press SEL (select) to finish the setting.
Automatic clock adjustment
When shipped from the factory, the clock built in
this unit is set to be readjusted automatically
using the CT (Clock Time) data in the RDS signal.
If you do not want to use automatic clock
adjustment, follow the procedure below.
• See also “Changing the general settings
(PSM)” on page 19.
1 Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.
2 Press 4 / ¢ (for KS-FX473R/KS-
FX470R) or / (for KS-F363R/KS-F360R)
to select “AUTO ADJ (adjustment).”
3 Press – to select “ADJ OFF.”
Now automatic clock adjustment is canceled.
4 Press SEL (select) to finish the setting.
To reactivate clock adjustment, repeat the
same procedure and select “ADJ ON” in step 3
by pressing +.
Note:
It takes about 2 minutes to adjust the time using the
CT data. So, you should not change the station for
more than 2 minutes continuously; otherwise, the
clock time will not be adjusted.
Station name
(PS NAME)
Station frequency
(FREQ)
Programme type
(PTY)
Clock time
(CLOCK)
EN09-14.KS-FX473[E]f 10/19/01, 9:02 PM13