Filter
Top Products
KS-FX384/KS-F184
Installation/Connection Manual
0105DTSMDTJEIN
EN
J
Handles
F
Washer (ø5)
G
Lock nut (M5)
H
Mounting bolt (M5 x 20 mm)
I
Rubber cushion
Parts list for installation and connection
The following parts are provided for this unit.
After checking them, please set them correctly.
A / B
Hard case/Control panel
C
Sleeve
D
Trim plate
E
Power cord
INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require information regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
• If you are not sure how to install this unit correctly, have it installed by a qualified technician.
This unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does not have this system, a voltage inverter is required, which can be purchased at
JVC car audio dealers.
1
Removing the unit
Before removing the unit, release the rear section.
Insert the two handles, then pull them as illustrated so
that the unit can be removed.
TROUBLESHOOTING
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• Noise interfere with sounds.
* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?
• Unit becomes hot.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• This unit does not work at all.
* Have you reset your unit?
When installing the unit without using the sleeve
In a Toyota for example, first remove the car radio and install the unit in its place.
When using the optional stay
Stay (option)
Install the unit at an angle of less than 30˚.
Screw (option)
Fire wall
Dashboard
Note : When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer
screws are used, they could damage the unit.
Bracket*
Bracket*
* Not included for this unit.
Flat type screws (M5 x 8 mm)*
Pocket
Flat type screws (M5 x 8 mm)*
GET0308-002A
[UI]
*
1
When you stand the unit, be
careful not to damage the fuse
on the rear.
Do the required electrical connections.
Bend the appropriate tabs to hold
the sleeve firmly in place.
Instal1-2_FX384_184[UI]f.p65 1/18/05, 9:06 AM1