Filter
Top Products
9
ENGLISH
KS-F160 [EN] GET0076-001A [J]
To tune to your favorite station
The unit automatically turns on
(if it has been off).
Your favorite station is turned in –
except when the tape is playing.
• If you press the button again,
the last received station will
be tuned in.
Tuning into a preset station
You can easily tune into a preset station.
Remember that you must store stations first. If you
have not stored them yet, see “Storing stations in
memory” on page 7.
1
Select the band (FM1 – 3, AM)
you want.
FM1 FM2
FM3
A M
F M
AM
2
Select the number (1 – 6) for the preset
station you want.
Scanning broadcast stations
When you press SCAN while
listening to the radio, station
scanning starts. Each time a
broadcast is tuned in, scanning
stops for about 5 seconds (tuned
frequency number flashes on the
display), and you can check what
program is now being broadcast.
If you want to listen to that program,
press the same button again to stop
scanning.
Changing the AM/FM channel
intervals
When using this unit in an area other than North
or South America:
When this unit is shipped from the factory, the
channel intervals are set to 10 kHz for AM and 200
kHz for FM. You can change the channel intervals
by following the procedure below.
1 Press SEL (select) for more than 2 seconds.
“CLOCK H”, “CLOCK M” or “AREA” appears on
the display.
2 If “AREA” does not appear, press
or until
it appears.
3 Press +.
“AREA EU” appears and the channel intervals
are set to 9 kHz for AM and 50 kHz (for manual
tuning) / 100 kHz (for searching) for FM.
To reset to the factory setting, follow the above
step 1 and 2, then press – in step 3 (“AREA US”
appears on the display.)
AREA EU: Select this when used in an area
other than North and South America.
AREA US: Select this when used in North or
South America.
EN06-09-KS-F160[J]f-1 10/8/01, 10:34 AM9