Filter
Top Products
4
D
E
F
KS-U57*
5
LINE IN
AV1-IN
AV2-INPUT
VIDEO OUT
Connecting the monitor
Before connecting the monitor, make sure the unit is turned off.
Video cord (not supplied)
Or
Rear side
KV-MR9010
9-INCH WIDESCREEN MONITOR
(not supplied)
Connecting the external amplifier
You can connect amplifier to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.
• Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.
*
3
Firmly attach the ground wire to the metallic body or to the chassis
of the car—to the place not coated with paint (if coated with paint,
remove the paint before attaching the wire). Failure to do so may
cause damage to the unit.
To the remote lead of other equipment or auto antenna if any
Y-connector (not supplied for this unit)Remote lead
Signal cord (not supplied for this unit)
Rear speakers
JVC Amplifier
Front speakers
Remote lead (Blue with white stripe)
JVC CD changer
CAUTION :
• Before connecting the CD changer, make sure that the unit is turned off.
*
4
Connecting cord supplied for your CD changer
Connecting the external components
• Refer also to page 15 of the
INSTRUCTIONS.
JVC CD changer
External component
CD changer jack
Set external input to “EXT IN” (see page 24 of the INSTRUCTIONS).
*
5
Line Input Adapter KS-U57 (not supplied for this unit)
External component
External component
Signal cord (not supplied for this unit)
Signal cord (not supplied for this unit)
Instal3-4_KD-SV3104[UI]f.indd 5Instal3-4_KD-SV3104[UI]f.indd 5 4/4/05 12:17:34 PM4/4/05 12:17:34 PM