Filter
Top Products
9
ENGLISH
Notes:
• A previously preset station is erased when a new
station is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.
Tuning into a preset station
You can easily tune into a preset station.
Remember that you must store stations first. If you
have not stored them yet, see “Storing stations in
memory” on page 8.
1
Select the band (AM, FM1 – 3).
2
Select the number (1 – 6) for the
preset station you want.
Manual preset
You can preset up to 6 stations in each band
(FM1, FM2, FM3 and AM) manually.
Ex: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band
1
Select the FM band (FM1 – 3) you
want to store FM stations into
(in this example, FM1).
• Each time you press the button, the FM
band changes as follows:
2
Tune into a station of 88.3 MHz.
3
Press and hold the number button
(in this example, 1) for more than
2 seconds.
4
Repeat the above procedure to
store other stations into other
preset numbers.
Press ¢ to tune in
stations of higher
frequencies.
Press 4 to tune in
stations of lower
frequencies.
8 9 10 11 127
FM1
AM
FM2 FM3
“P1” flashes for a few seconds.
FM1 FM2 FM3
EN07-09.KD-S717[EE]2 00.11.23, 5:58 PM9