Filter
Top Products
ENGLISH
15
Indications Item
( : Initial)
Setting, [reference page]
AUDIOBOOKS *
2
Speed control of
“Audiobook”
• NORMAL
• FASTER
• SLOWER
: You can select the playback speed of the “Audiobook” sound file in
your iPod.
SCROLL *
3
Scroll
• ONCE
• AUTO
• OFF
: Scrolls the displayed information once.
: Repeats scrolling (at 5-second intervals).
: Cancels.
• Pressing DISP for more than one second can scroll the display
regardless of the setting.
L/O MODE
Line output mode
• REAR
• SUB.W
: Select if the REAR LINE OUT terminals are used for connecting the
speakers (through an external amplifier).
: Select if the REAR LINE OUT terminals are used for connecting a
subwoofer (through an external amplifier).
SUB.W FREQ *
4
Subwoofer cutoff
frequency
• LOW
• MID
• HIGH
: Frequencies lower than 90 Hz are sent to the subwoofer.
: Frequencies lower than 135 Hz are sent to the subwoofer.
: Frequencies lower than 180 Hz are sent to the subwoofer.
TAG DISPLAY
Tag display
• TAG ON
• TAG OFF
: Shows the Tag information while playing MP3/WMA tracks, [9].
: Cancels.
AMP GAIN
Amplifier gain
control
• LOW POWER
• HIGH POWER
: VOLUME 00 – VOLUME 30. (Select this if the maximum power of the
speaker is less than 50 W to avoid damaging the speaker.)
: VOLUME 00 – VOLUME 50.
IF BAND
Intermediate
frequency band
• AUTO
• WIDE
: Increases the tuner selectivity to reduce interference noise between
close stations. (The stereo effect may be lost.)
: Subject to interference noise from adjacent stations, but the sound
quality will not be degraded and the stereo effect will remain.
AREA
Tuner channel
interval
• AREA US
• AREA EU
• AREA SA
: When using in North/Central/South America. AM/FM intervals are
set to 10 kHz/200 kHz.
: When using in any other areas. AM/FM intervals are set to 9 kHz/
50 kHz (100 kHz during auto search).
: When using in South American countries where FM interval is
100 kHz. AM interval is set to 10 kHz.
*
2
Displayed only when an iPod is connected and playback is controlled from the unit.
*
3
Some characters or symbols will not be shown correctly (or will be blanked) on the display.
*
4
Displayed only when “L/O MODE” is set to “SUB.W.”
EN14-23_KD-APD49[J]f.indd 15EN14-23_KD-APD49[J]f.indd 15 11/1/07 3:11:45 PM11/1/07 3:11:45 PM