Filter
Top Products
4
~
Powered subwoofer
The subwoofer connected can reproduce the bass sounds
recorded in front left and right channels, but cannot
reproduce the LFE signals in DVD multi-channel discs.
• Before plugging the unit to the main supply, make sure that
the powered subwoofer is turned off.
Ÿ
AM/FM antenna
To assemble the AM loop antenna
To connect AM/FM antenna
For better AM/FM reception
• Disconnect the supplied FM antenna, and connect to an
outdoor FM antenna using a 75
Ω
wire with coaxial type
connector (IEC or DIN45325).
!
TV/monitor
Connect only component cord at one time.
• To select progressive scanning mode (see page 15), use
COMPONENT jacks.
• After connecting a TV, select the proper video signal mode
according to the connection method. See “Changing the
Scanning Mode” on page 15.
⁄
Digital audio component
• Set “DIGITAL AUDIO OUTPUT” in the “AUDIO” menu
correctly according to the connected digital audio
equipment (see page 37). If
the
setting is incorrect, loud
noise may be generated causing damage to the speakers.
• Digital audio signals are output from this System only when
“DVD/CD” is selected as the source.
SUB -
WOOFER
OUT
From the powered
subwoofer
(not supplied)
Extend it so that you can obtain the best
reception.
FM antenna (supplied)
AM loop antenna
(supplied)
AM loop antenna (supplied)
Keep it connected.
FM outdoor antenna
(not supplied)
Vinyl-covered wire
(not supplied)
Extend it horizontally.
Green
Blue
Red
Component video cord
(not supplied)
S-video cord (not supplied)
Composite video cord (supplied)
Protective cap
UX-G70[U].book Page4 Monday, April17, 2006 5:18PM