Filter
Top Products
36
IMPORTANT
Before using the remote control for the
following operation;
1 Set the remote control mode selector to
AUDIO.
2 Press FM/AM.
On the remote control:
1 Press FM/AM repeatedly to select the
band.
Example:
When the system is tuned in to 810 kHz.
2 Press TUNING 9/( repeatedly until
you find the frequency you want.
When you hold down the button until the system starts
searching for stations and then release it, the system stops
searching automatically when a station of sufficient signal
strength is tuned in to.
On the center unit:
1 Press SOURCE repeatedly to select the
band (FM or AM).
2 Press TUNING +/– repeatedly until you
find the frequency you want.
NOTE
• When an FM stereo program is received, the ST indicator lights on
the display window.
The buttons described below are used on pages 36 and 37.
Number
buttons
Remote
control mode
selector
Cursor
(3/2)
Manual tuning
Tuner operations
TH-C60-40[J]rev-4.book Page 36 Tuesday, April 18, 2006 2:16 PM