Filter
Top Products
English
3
Connection
7 Precautions
Before connecting:
• Turn off the power to the amplifier before connecting the
speaker system; otherwise, the speakers may be damaged.
• The impedance of the speaker is 6 Ω.
If this does not match with the speaker impedance range
indicated on the amplifier, you cannot connect this system to
the amplifier.
• The maximum power handling capacity of the SX-WD8 is
150 W. Excessive input will result in abnormal noise and
possible damage.
• Be sure to turn down the volume level on the amplifier to
prevent unwanted noise before performing following
operations:
– Turning on or off other components
– Operating the amplifier
– Tuning FM stations
– Fast-forwarding a tape
– Continuously reproducing high frequency oscillation or high
pitch electronic sounds
– Connecting or disconnecting a microphone
• When using a microphone, do not aim it at the speakers or
use it near the speakers; otherwise, the howling which occurs
may damage the speakers.
• Before replacing the cartridge, always turn off the power both
to the amplifier and to the turntable; otherwise, the clicking
noise may damage the speakers.
7 Connecting the speaker system to the amplifier
• Twist and remove the insulation at the end of
each speaker cord before connecting.
• Make sure to match the polarity (ª and ·); otherwise, the
surround effect will become less effective.
123
To the speaker ª terminal of amplifier
Silver
ª terminal
(Red hoop)
· terminal
(Black hoop)
Copper
To the speaker · terminal of amplifier
About Speaker Grille
The speaker grille is removable as illustrated below:
To remove the speaker grille, insert your fingers at the top of
the speaker grille, then pull towards you. Repeat the procedure at
the bottom of the speaker grille.
To attach the speaker grille, put the projections of the speaker
into the holes of the speaker grille.
• Do not push the speaker grille strongly.
Specifications
Type: 2-way 3-speaker bass-reflex type
Magnetically-shielded type
Speakers
Mid and low range: 10.5 cm (4
3
/
16
in.) wooden cone
Tweeter: 2.0 cm (
13
/
16
in.) wooden dome
Power handling capacity: 150 W
Impedance: 6 Ω
Crossover frequency: 3 800 Hz
Frequency range: 50 Hz to 50 000 Hz
Sound pressure level: 84.5 dB/W•m
Dimensions (W x H x D): 143 mm x 405 mm x 249 mm
(5
11
/
16
in. x 16 in. x 9
13
/
16
in.)
Mass: 6.3 kg (13.9 lbs)
Supplied accessories: • Feet (4)
• Speaker cord (3 m) (1)
• Screw hole caps (2)
Design and specifications subject to change without notice.
Speaker grille
Projections
Holes
Speaker grille
02-03_SX-WD8[J].p65 11/04/2005, 12:27 PM3