Filter
Top Products
34
You can use the supplied remote control to operate not only
this receiver but also other JVC products.
• Refer also to the manuals supplied with the other products.
– Some JVC VCRs can accept two types of control signals—
remote codes “A” and “B.” This remote control can operate a
VCR whose remote control code is set to “A.”
– Some JVC DVD recorders can accept four types of control
signals. This remote control can operate a DVD recorder
whose remote control code is set to the initial code. For
details, refer to the manual supplied with the DVD recorder.
• To operate other products, aim the remote control directly at the
remote sensor on the target product.
7 TV
Operating other
JVC products
You can always perform the following operations:
TV VOLUME +/–: Adjust the volume on the TV.
TV/VIDEO: Change the input mode (either video
input or TV tuner) on the TV.
After pressing TV, you can perform the following operations on the
TV.
STANDBY/ON Turn on or off the TV.
TV/DBS/CATV:
CHANNEL +/–: Change the channel numbers.
1 – 9, 0, 100+: Select the channel numbers.
RETURN (10): Switch between the previous channel
and the current channel.
7 VCR
You can always perform the following operation:
STANDBY/ON Turn on or off the VCR.
VCR:
After pressing VCR, you can perform the following operations on
the VCR.
CHANNEL +/–: Change the channel numbers on the
VCR.
3: Start playback.
7: Stop playback.
8: Pause playback. To release it, press 3.
FF: Fast-wind a tape.
REW: Rewind a tape.
REC PAUSE: Enter recording pause. To start
recording, press this button then 3.
1
4
7
10
2
5
8
0
3
6
9
10
1
4
7
10
2
5
8
0
3
6
9
10