Filter
Top Products
25
English
Activating the DSP Modes
You can use only one DSP mode at a time. When a DSP mode is
activated, another DSP mode is canceled if in use.
For Dolby Pro Logic, Dolby Digital, and DTS
Digital Surround
On the front panel:
1. Press SURROUND so that the
lamp next to the button lights up.
• Each time you press the button, the Dolby/
DTS Surround mode turns on and off
alternately.
2. Select and play a sound source.
• To enjoy Dolby Pro Logic, play back a software encoded with
Dolby Surround and labeled with
DOLBY SURROUND
mark.
• To enjoy Dolby Digital, play back a software encoded with
Dolby Digital and labeled with
DIGITAL
mark.
• To enjoy DTS Digital surround, play back a software encoded
with DTS Digital Surround and labeled with
mark.
To cancel the Dolby/DTS Surround mode
Press SURROUND again so that the lamp goes
off. (“SURROUND OFF” appears on the
display.)
From the remote control:
1. Press SURROUND so that the
lamp on the front panel lights up.
• Each time you press the button, the Dolby/
DTS Surround mode turns on and off
alternately.
• You can also turn on Dolby/DTS Surround
mode by pressing SURROUND MODE.
(See page 22 for more details.)
2. Select and play a sound source.
• To enjoy Dolby Pro Logic, play back a software encoded with
Dolby Surround and labeled with
DOLBY SURROUND
mark.
• To enjoy Dolby Digital, play back a software encoded with
Dolby Digital and labeled with
DIGITAL
mark.
• To enjoy DTS Digital surround, play back a software encoded
with DTS Digital Surround and labeled with
mark.
To cancel the Dolby/DTS Surround mode
Press SURROUND again. (“SURROUND OFF”
appears on the display.)
For the other DSP modes
On the front panel:
1. Press DSP MODE repeatedly until
the mode you want appears on the
display.
• Each time you press the button, the DSP
modes change. (See page 20 for more
details.)
2. Select and play a sound source.
• To enjoy 3D-PHONIC and JVC Theater Surround, play back a
software encoded with Dolby Surround and labeled with
DOLBY SURROUND
mark.
To cancel the DSP mode
Press DSP MODE repeatedly until “DSP OFF”
appears on the display.
From the remote control:
1. Press SURROUND MODE
repeatedly until the DSP mode you
want appears on the display.
• Each time you press the button, the DSP
modes change. (See page 20 for more
details.)
2. Select and play a sound source.
• To enjoy 3D-PHONIC and JVC Theater Surround, play back a
software encoded with Dolby Surround and labeled with
DOLBY SURROUND
mark.
To cancel the DSP mode
Press SURROUND MODE repeatedly until
“DSP OFF” appears on the display.
DSP MODE
DSP MODE
SURROUND
SURROUND
SURROUND
SURROUND
MODE
SURROUND
MODE
SURROUND
EN18_25.RX-6500V[J] 99.12.16, 1:07 PM25