Filter
Top Products
13
14
15
16
GVT0277-017B EN_NX-D2[J] Operating Guide 02
GVT0277-017B EN_NX-D2[J] Operating Guide 02
GVT0277-017B EN_NX-D2[J] Operating Guide 02
GVT0277-017B EN_NX-D2[J] Operating Guide 02
Enjoying Karaoke
IMPORTANT
• Always set MIC LEVEL to “MIN” (0) before disconnecting
the microphone.
• MIC LEVEL adjustment is valid for both microphones
connected to the MIC 1 and MIC 2 jacks.
• If the microphone does not work properly, please
disconnect it and connect again.
Singing Along (Karaoke)
1 Connect the microphone(s) (not supplied) to the
MIC 1 and/or MIC 2 jack.
2 Start playing a source.
3 Sing into the microphone.
4 Adjust the microphone level and volume.
On the main unit On the remote
Changing the Karaoke Setting
ECHO—To apply an echo to your voice.
• You can adjust the echo level from ECHO OFF (no effect)
to ECHO 6 (strongest).
MIC VOL—To change the mic volume.
• The mic volume level can be adjusted in 16 steps from
MIN (0) to MAX (15).
DO NOT keep the microphones connected while they are
not in use.
Sound Adjustments
Adjusting the Sound
Various Bass Effect—To create a sound suitable for the
playback source.
On the main unit On the remote
LITEnEASY
Suitable for Karaoke and classical music. You
can obtain a comfortable bass sound.
MOVIE
Suitable for a video source and playback of
external component. You can obtain a strong
bass sound.
TECHNO
Suitable for disco or techno music. You can
obtain a strong bouncy bass sound.
TURBO
Suitable for most kinds of music and
playback of external component. You can
obtain a balanced bass sound.
AUTO
The System automatically applies TURBO,
LITEnEASY, MOVIE or TECHNO
according to the playback source (initial
setting).
OFF
No sound effect.
Superbass level adjustment—From level 1 to level 5.
On the main unit
On the remote
Selecting the Sound Modes
Sound Mode (for CD, USB and iPod)—To select
one of the preset Sound Modes.
ROCK
Boosts low and high frequency. Good for
acoustic music (initial setting).
POP
Good for music with an emphasis on vocal.
CLASSIC
Good for classical music.
DANCE
Increases resonance and bass.
HALL
Adds depth and brilliance to the sound.
STADIUM
Adds clarity and spreads the sound, as in an
outdoor stadium.
USER1/2/3
Your individual mode stored in memory.
See below.
FLAT
Canceled.
To create your own sound modes (User Mode)
1 Select one of the preset Sound Modes.
2 Press SET.
3 Press 4 to select BASS (bass) or TRE (treble) to
adjust.
4 Press UP or DOWN to adjust the parameters
then press ENTER/SET.
5 Press ¢ to select one of the user modes
(USER1–3) to store your setting into.
6 Press SET to finish.
Learning More about This System
Connections
• Make sure the antenna conductors do not touch any other
terminals, connecting cords or the power cord. Also, keep
the antennas away from metallic parts of the System,
connecting cords, and the power cord. These could cause
poor reception.
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the
System.
• The speakers are magnetically shielded to avoid color
distortions on TVs. However, if not installed properly,
it may cause color distortions. So, pay attention to the
following when installing the speakers.
– When placing the speakers near a TV set, turn off the
TV’s main power switch or unplug it before installing
the speakers.
Then wait at least 30 minutes before turning on the TV’s
main power switch again.
– Some TVs may still be affected even though you have
followed the above instructions. If this happens, move
the speakers away from the TV.
• You cannot connect a computer and JVC Everio
camcorder to the USB terminals of the System.
• Electrostatic shock at connecting a USB device may cause
abnormal playback of the device. In this case, disconnect
the USB device then turn off this unit.
Basic Operations
Setting the ECO (Ecology) Mode:
• If you turn on the Daily Timer while the ECO mode is
activated, the ECO mode is canceled.
Listening to a Disc/USB Device
JVC bears no responsibility for any loss of data in the
USB mass storage class device while using this System.
• When connecting with a USB cable, use the USB 2.0 cable
whose length is less than 1 m.
• You can connect a USB device such as a USB flash memory
device, hard disk drive, multimedia card reader, etc. to this
System.
• When you change the source to “CD” or “USB,” it may take
a while to activate the source.
• While the System is reading a disc, the source may not
change to “USB” properly. Press 7 to stop the disc before
changing the source to “USB.”
• On some discs, the actual operations may be different from
what is explained in this manual due to the programming
and disc structure; such differences are not a malfunction
of this System.
• The total number of tracks (files) that the System can detect
is 4 000.
• The System recognizes up to...
– 999 tracks (files) per group.
– 99 groups per disc.
Unplayable files are also counted in the total file number.
Playable files which do not belong to any groups are
recognized as files of group 1.
Program Play/Random Play:
• Program is cleared in the following cases:
– When the System is turned off (standby).
• During programming steps...
– Your entry will be ignored if you have tried to program
an item number that does not exist (for example,
selecting track 14 on a disc that only has 12 tracks).
– For MP3/WMA files, you can program up to 99 files.
– You cannot select the 151st or later tracks.
Listening to the Radio
• If you store a new station into an occupied preset number,
the previously stored station in that number will be erased.
• When you unplug the power cord accidentally or if a power
failure occurs, the preset stations may be erased. If this
happens, preset the stations again.
Timer Operations
General:
• When the System is on standby, you cannot set the clock
and Daily Timer.
Setting the Clock:
• “0:00” will flash on the display until you set the clock.
• The clock may gain or lose 1 to 2 minutes per month. If this
happens, reset the clock.
Setting the Daily Timer:
• If you do not specify the preset station or track number
correctly while setting a timer, the currently selected station
or the first track will be played when the timer is activated.
• When you unplug the power cord or if a power failure
occurs, the timer will be canceled. You need to set the clock
first, then the timer again.
• If you set the Sleep Timer after Daily Timer starts playing
the selected source, Daily Timer is canceled.
Sound Adjustments
Adjusting the Sound:
• This function also affects the sound through the
headphones.
Enjoying Movies/Music from your iPod
JVC is not responsible for any loss of or damage to iPod
that might result from the use of this product.
• Apple is not responsible for the operation of this device or
its compliance with safety and regulatory standards.
• Sound distortion may occur when playing back audio
sources with a high recording level. When distortion
occurs, it is recommended to turn off the equalizer
of iPod. For information on operating iPod, see the
instruction manual for iPod.
• If iPod does not play correctly, update iPod software to the
latest version.
• For details about updating iPod, check on the Apple web
site <http://www.apple.com>.
• JVC does not assure the compatibility of iPod released
after April 2009 with this unit.
EN_NX-D2[J].indb 4 10.1.7 4:28:06 PM