JVC GVT0150-008UW Home Theater System User Manual


 
39
Tuner operations
IMPORTANT
Before using the remote control for the
following operation;
1 Set the remote control mode selector to
AUDIO.
2Press FM/AM.
NOTE
When FM or AM is selected as the source, you can select All Channel
Stereo (ALL ST) and SURR OFF mode.
Some countries space AM stations 9 kHz apart, and some countries
use 10 kHz spacing.
You can only change the AM tuner interval spacing while tuning
into an AM station.
You can operate the following procedures using the buttons on
the front panel.
On the center unit ONLY:
7 To change the interval spacing into 10 kHz
Press 8 while holding down 7.
7 To change the interval spacing into 9 kHz
Press 3 while holding down 7.
1 Press FM/AM repeatedly to select the
band.
Example:
When the system is tuned in to 810 kHz.
2 Press TUNING 9/( repeatedly until
you find the frequency you want.
When you hold down the button until the system starts
searching for stations and then release it, the system stops
searching automatically when a station of sufficient signal
strength is tuned in to.
NOTE
When an FM stereo program is received, the ST indicator lights on the
display window.
The buttons described below are used on pages 39 to 40.
FM/AM
TUNING
AUDIO
TUNING
FM MODEMEMORY
/
Number buttons
Remote control
mode selector
Setting the AM tuner
interval spacing
Manual tuning
8
1
0
AM
kHz
TH-C3C6[UJ].book Page 39 Monday, April 4, 2005 6:56 PM