JVC GVT0150-008UG Home Theater System User Manual


 
Advanced operations
37
IMPORTANT
Before using the remote control for the following
operation;
Set the remote control mode selector to
AUDIO.
NOTE
Before you start operation;
There is a time limit when doing the following steps. If the setting is
cancelled before you finish, start from step 1 again.
1 Press SETTING.
Example:
2 Press Cursor Y/5 to select the item
you want to set.
DEC (Decode):
When you play an external source (DBS D is selected as a
source) that was encoded with Dolby D or DTS Digital
Surround, the following symptoms may occur;
No sound comes out at the beginning of playback.
Noise comes out while searching for or skipping chapters
or tracks.
A/PCM (Auto/PCM):
Normally select this. The system automatically
detects the incoming signals.
DD: Select this if the symptoms above occur when
playing a disc (or software) encoded with Dolby
D.
DTS: Select this if the symptoms above occur when
playing a disc (or software) encoded with DTS
Digital Surround.
3 Press Cursor 3/2 to make an
adjustment or selection.
Example:
The adjustment is set and the display automatically disappears
a few seconds later.
NOTE
When “DD” or “DTS” is selected, if a signal encoded with another
digital format comes in, you cannot listen to the sound. (The
GDIGITAL or C indicator flashes.)
Sound and other settings
A
E
D/M
C.
C
P
E
DDD
C.
See page 26 for button locations.
TH-C3C6C7C9[AUWUSUNUGUX].book Page 37 Monday, April 25, 2005 8:56 PM