Filter
Top Products
2 – EN
INSTRUCTIONS
Sound adjustments
Indication (For)
BAS
(bass)
MID
(mid-range)
TRE
(treble)
LOUD
(loudness)
USER (Flat sound) 00 00 00 OFF
ROCK
(Rock or disco music) +03 00 +02 OFF
CLASSIC (Classical music) +01 00 +03 OFF
POPS
(Light music) +02 +01 +02 OFF
HIP HOP
(Funk or rap music) +04 –02 +01 OFF
JAZZ
(Jazz music) +03 00 +03 OFF
FM station automatic presetting —SSM (Strong-station Sequential Memory)
You can preset six stations for each band.
When an FM stereo broadcast is hard to receive
Adjusting the sound
BAS*
2
(bass) : Adjust the bass. –06 to +06
MID*
2
(mid-range) : Adjust the middle frequencies sound level. –06 to +06
TRE*
2
(treble) : Adjust the treble. –06 to +06
FAD*
3
(fader) : Adjust the front and rear speaker balance. R06 to F06
BAL (balance) : Adjust the left and right speaker balance. L06 to R06
LOUD*
4
(loudness) : Boost low and high frequencies to
produce a well-balanced sound at
a low volume level.
LOUD ON or
LOUD OFF
SUB.W (subwoofer) :
Adjust the subwoofer output level.
00 to 08
VOL (volume) : Adjust the volume. 00 to 50
(or 00 to 30)*
5
*
1
Displayed only when “L/O MODE” is set to “WOOFER.”
*
2
When you adjust the bass, mid-range, or treble, the adjustment you have made
is stored for the currently selected sound mode (iEQ) including “USER.”
*
3
If you are using a two-speaker system, set the fader level to “00.”
*
4
The adjustment made (LOUD ON/LOUD OFF) will be applied to all sound modes
(iEQ).
*
5
Depending on the amplifier gain control setting.
Preset values
OPERATIONS
Basic operations
Select the source.
• Turn on the power.
• Turn off the power [Hold].
• Attenuate the sound (if the
power is on).
Volume control.
Detach the panel.
Check the current clock time/other information.
See also “CLK DISP“ of “General settings—PSM.”
Control panel
Radio operations
Select preset station.
• You can also use 5 / ∞ to select preset station.
Manual presetting
Example: Storing the FM station of 92.5 MHz into preset number 4 of the FM1 band.
Display window
Disc indicator
Playback mode / item indicator
• MO: Lights up in monaural mode.
• ST: Lights up when receiving an FM stereo
broadcast with sufficient signal strength.
• Source display
• Track number
• Volume level indicator
• Time countdown indicator
Main display (time,
playback information)
EQ (equalizer) indicator
Sound mode (iEQ: intelligent equalizer)
indicator
LOUD (loudness) indicator
Tr (track) indicator
SETTINGS
Remote controller—RM-RK50
• Turns the power on if pressed briefly or
attenuates the sound when power is on.
• Turns the power off if pressed and held.
• Changes the FM/AM bands with 5 U.
• Changes the preset stations with D ∞.
• Adjusts the volume level.
• Selects the sound mode
(iEQ: intelligent equalizer).
• Selects the source.
• Searches for stations if pressed briefly.
• Fast-forwards or reverses the track if
pressed and held.
• Changes the track of the disc if pressed
briefly.
Select “FM/AM.”
Select the bands.
Search for a station—Auto Search.
Manual Search: Hold either one of the buttons until “M” flashes on the display, then press it repeatedly.
Remote sensor
DO NOT expose to strong light.
Reception improves, but the stereo effect will be lost.
• MO indicator lights up.
To restore the stereo effect, repeat the same procedure.
7 Installing battery
Warning: To prevent accidents and damage
• Do not install any battery other than CR2025 or its
equivalent.
• Store out of reach of children.
• Do not recharge, short, or dismantle.
• Do not dispose of in fire.
• Do not carry around with other metallic materials.
Lithium coin battery (CR2025)
For USA-California Only: This product contains a CR Coin Cell Lithium Battery which contains Perchlorate Material—
special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate
7 Features
See reverse page \
Stereo mini plug (not supplied)
Portable audio player, etc.
Turn on the connected
component and start
playing the source.
External component operations
You can connect an external component to the AUX (auxiliary) input jack on the
control panel.
Disc operations
Selecting the playback modes
After pressing M MODE, press the following buttons to...
TRK RPT : Plays the current track
repeatedly.
RPT OFF : Cancels.
ALL RND : Plays all tracks of the current
disc at random.
RND OFF : Cancels.
Skipping a track quickly during play
Example: Select track 32
Changing the display information
: Clock with the current track number
: The elapsed playing time with the current track
number
*
If the current disc is an audio CD, “NO NAME” appears.
Prohibiting disc ejection
You can lock a disc in the loading slot.
To cancel the prohibition, repeat the same procedure.
Turn on the power.
Insert disc.
All tracks will be played repeatedly until you change the source or eject the disc.
Eject disc.
• Press SRC to
listen to another
playback source.
[Press] Select track number (01 – 06).
[Hold] Select track number (07 – 12).
•
4 / ¢
[Press] Go to the next or previous track.
[Hold] Fast-forwards or reverses the track.
EN_KD-S15[J]_f.indd 2EN_KD-S15[J]_f.indd 2 5/13/08 5:16:00 PM5/13/08 5:16:00 PM