Filter
Top Products
8
Other convenient tuner functions
SEL
SSM ¢
SSM 4
+/–
SCAN/RPT (For KS-FX230)
SCAN (For KS-F130)
MO/RND (For KS-FX230)
MO (For KS-F130)
Scanning broadcast stations
When you press SCAN/RPT (for KS-FX230) or SCAN (for KS-F130) while listening to the
radio, station scanning starts. Each time a broadcast is tuned in, scanning stops for about 5
seconds (tuned frequency number flashes on the display), and you can check what program
is now being broadcasted.
If you want to listen to that program, press the same button again to stop scanning.
Selecting FM reception sound
When an FM stereo broadcast is hard to receive:
Press MO/RND (mono/random: for KS-FX230) or MO (mono: for KS-F130) while listening to
an FM stereo broadcast. The sound you hear becomes monaural but reception will be improved.
To restore the stereo effect, press the same button again.
Changing the AM/FM channel intervals
When using this unit in an area other than North or South America:
When this unit is shipped from the factory, the channel intervals are set to 10 kHz for AM and
200 kHz for FM. You can change the channel intervals by following the procedure below.
1 Press SEL (select) for more than 2 seconds.
“CLOCK H,” “CLOCK M” or “AREA” appears on the display.
2 If “AREA” does not appears, press SSM ¢
or SSM 4
until it appears.
3 Press +.
“AREA EU” appears and the channel intervals are set to 9 kHz for AM and 50 kHz (for
manual tuning) / 100 kHz (for searching) for FM.
To reset to the factory setting, follow the above step 1 and 2, then press – in step 3 (“AREA
US” appears on the display.)
AREA EU: Select this when used in an area other than North and South America.
AREA US: Select this when used in North or South America.
ST
LOUD
MO
LOUD
Lights when receiving an
FM broadcast in stereo.
04-08.KS-FX230/F130BK 97.11.4, 0:56 PM8