JVC CA-MXJ30 Stereo System User Manual


 
– 9 –
English
Common Operations
Setting the Clock
Before operating the unit any further, first set the clock built
in this unit.
1
Press PANEL OPEN/CLOSE.
The unit is turned on and the Powered Rolling
Panel opens automatically.
2
Press TIMER/CLOCK.
The hour digits start flashing on the display.
3
Press 4 or ¢ to adjust the
hour, then press SET.
If you want to correct the hour after pressing
SET, press CANCEL. The hour digits start
flashing again.
4
Press 4 or ¢ to adjust the
minute, then press SET.
To check the clock time
Press DISPLAY while playing any source.
Each time you press the button, the source
indication and the clock time alternate on the
display.
To adjust the clock again
If you have adjusted the clock before, you need to press
TIMER/CLOCK repeatedly until the clock setting mode is
selected.
Each time you press the button, the timer/clock setting
modes change as follows:
If there is a power failure
The clock loses the setting and is reset to “0:00.” You need to set the
clock again.
Turning On the Power and Selecting the
Sources
When you press the play button for a particular source (FM/
AM, CD 6, AUX, and TAPE 2 3), the unit turns on, and
the Powered Rolling Panel opens automatically (and the unit
starts playing the source if it is ready — COMPU PLAY
CONTROL).
To listen to the FM/AM (MW/LW) broadcasts, press FM/
AM. (See pages 11 – 13.)
To play back CDs, press CD 6. (See pages 14 – 16.)
To play back tapes, press TAPE 2 3. (See page 17.)
To select the external equipment as the source, press AUX.
To turn on the unit without playing, press
so that the STANDBY lamp goes off.
The Powered Rolling Panel opens automatically.
To turn off the unit (on standby), press
again so that the STANDBY lamp lights up.
The Powered Rolling Panel also closes.
A little power is always consumed even while the
unit is on standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “0:00” right away, while the tuner preset
stations (see page 11) will be erased in a few days.
TIMER
/CLOCK
DAILY
Canceled
ON TIME
ON TIME
Clock
setting
(The hour digits start flashing.)
REC
FM AM
/
CD
TAPE
AUX
PANEL
OPEN / CLOSE
DISPLAY
PRESET
PRESET
STANDBY
STANDBY
ST
A.BASS EX
REC
S.MODE
ST
A.BASS EX
REC
S.MODE
ST
A.BASS EX
REC
S.MODE
ST
A.BASS EX
REC
S.MODE
SET
SET
EN01-13.CA-MXJ30/330/35R[E]/f 99.2.19, 4:55 PM9