Filter
Top Products
56
English
Using Recording Timer
With Recording Timer, you can make a tape of a radio broadcast
automatically.
Before you set the recording timer, set the preset numbers for
the radio stations (see page 22).
• You can set the timers whether the unit is on or off.
How Recording Timer actually works
The unit automatically turns on, tunes in to the specified station, sets
the volume level to “MIN,” and starts recording when the on-time
comes. (“REC” and the REC indicator on the display flash just
before the on-time. The REC indicator continues flashing while the
timer is operating.) Then, when the off-time comes (“REC OFF”
appears on the display just before the off-time), the unit
automatically turns off (standby).
The timer setting remains in memory until you change it.
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
2
again.
• To correct a mistake while setting the timer, press CANCEL/
DEMO.
On the front panel ONLY:
1
Insert a recordable cassette with the exposed part
of the tape down.
2
Press CLOCK/TIMER repeatedly until
“REC” appears on the display.
The (Timer) indicator lights up and the REC (Recording
Timer) indicator starts flashing.
• Each time you press the button, the timer setting modes
change as follows:
3
Press CLOCK/TIMER again.
“TIMER” appears for about 2 seconds, then the unit enters on-
time setting mode.
4
Set the on-time you want the unit to turn on at.
(1) Turn ¢ / 4 to set the hour, then press SET/DISPLAY.
(2) Turn ¢ / 4 to set the minute, then press SET/
DISPLAY.
“SET” appears for about 1 second, then the unit enters off-
time setting mode.
5
Set the off-time you want the unit to turn off
(standby) at.
(1) Turn ¢ / 4 to set the hour, then press SET/DISPLAY.
(2) Turn ¢ / 4 to set the minute, then press SET/
DISPLAY.
“SET” appears for about 1 second, then the unit enters
preset station selection mode.
6
Select a preset station.
(1) Turn ¢ / 4 to select the band (“TUNER FM” or
“TUNER AM”), then press SET/DISPLAY.
“SET” appears for about 1 second.
(2) Turn ¢ / 4 to select a preset station number, then press
SET/DISPLAY.
The REC (Recording Timer) indicator stops flashing and
remains lit. “OK
” appears on the display for about 2
seconds.
Then the settings you have done are shown in sequence for
your confirmation.
7
Press to turn off the unit (standby) if
necessary.
• The unit will turn on about one minute before the on-time
comes.
• If you want to listen to another source while recording
Press 7 (or REC START/STOP on the front panel) to stop
recording. Without stopping it, you cannot change the source.
• If you unplug the AC power cord or if a power failure occurs
Once you set the timer, the timer settings may remain stored in
memory for a few days. Check whether or not the timer settings
still remain.
DAILY
(Daily Timer on/off)
Canceled
TIMER
(Daily Timer setting)
TIMER
(Recording Timer setting)
REC
(Recording Timer on/off)
Clock
setting
(The hour digits start flashing.)
53-57HX-Z77&55[U]6.p65 03.8.18, 10:43 AM56