Filter
Top Products
– 19 –
English
Playing at Random—Random Play
The tracks of the currently selected disc will be played at
random.
• To use Repeat Play (see page 20) for Random Play, press
REPEAT after starting Random Play. Only REPEAT 1 and
REPEAT ALL can be selected for Random Play.
1
Load a disc.
2
Press the corresponding disc number (CD1,
CD2, or CD3) button where a disc is loaded
in step
1
, then press 7.
3
Activate the Random Play mode.
On the unit:
Press CD PLAY MODE repeatedly
until “CD RANDOM” appears on
the display.
• Each time you press the button, the play
mode changes as follows:
On the remote control:
Press RANDOM so that
“CD RANDOM” appears
on the display.
• The RANDOM indicator also lights up on the display.
4
Press CD 3¥8.
The tracks are randomly played.
Random Play ends when all the tracks
of the current disc are played once.
To skip the currently playing track, turn 4 / ¢ to the
right (or press ¢ (¡) on the remote control).
If you turn 4 / ¢ to the left (or press 4 (1) on
the remote control)
You cannot go back to the previous tracks during Random Play.
To stop playing, press 7.
To exit from Random Play mode, press CD PLAY MODE
repeatedly until the RANDOM indicator goes off (or press
RANDOM on the remote control) after playback stops.
CD PLAY
MODE
RANDOM
CD
CD PROGRAM
Canceled
(Continuous Play)
CD RANDOM
RANDOM
1 2 3 4
5 6 7 8
9 1011 12
CD3
CD2
CD1
To check the program contents
On the remote control ONLY:
Before playing, you can check the
program contents by pressing
4 (1) or ¢ (¡).
• 4 (1) : Shows the programed
tracks in the reverse order.
• ¢ (¡) : Shows them in the programed order.
To modify the program
Before or after playing, you can erase the last
programed tracks by pressing CANCEL/DEMO
(or press PROGRAM CANCEL on the remote
control).
• Each time you press the button, the last
programed track is erased from the program.
To add tracks in the program before playing, simply select
the track numbers you want to add by following step
4
of the
programming procedure. If you want to add tracks from
another disc, follow steps
3
and
4
.
To erase the entire program before or after playing, press
and hold 7 until “CD PROGRAM” appears on the display.
• The program you have made will be erased,
– when you exit from Program Play mode,
– when you unplug the AC power cord, or
– when a power failure occurs.
PROGRAM
CANCEL
CANCEL / DEMO
EN14-21.CA-HXZ3[UW]f.p65 6/7/02, 10:37 AM19