Filter
Top Products
17
English
Tuning in a Station
On the unitOn the unit
ONLY
::
1
Press FM/AM u.
The unit automatically turns on and tunes in the
previously tuned station (either FM or AM). The
Powered Rolling Panel automatically opens.
• Each time you press the button, the band
alternates between FM and AM.
2
Press and hold TUNING – / + x for more
than 1 second.
The unit starts searching for stations and stops when
a station of sufficient signal strength is tuned in.
If a program is broadcast in stereo, the STEREO indicator lights
up.
To stop during searching, press TUNING – / + x.
When you press TUNING – / +
xx
xx
x
briefly and
repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is hard to receive or noisy,
press FM MODE * on the remote control so that the
MONO indicator lights up on the display. Reception
improves.
To restore the stereo effect, press FM MODE * again so that
the MONO indicator goes off.
In this stereo mode, you can hear stereo sounds when a program is
broadcast in stereo.
Presetting Stations
You can preset 30 FM and 15 AM stations.
In some cases, test frequencies have been already memorized for
the tuner since the factory examined the tuner preset function before
shipment. This is not a malfunction. You can preset the stations you
want into memory by following the presetting method.
• There is a time limit in doing the following steps. If the setting is
cancelled before you finish, start from step 1 again.
1
Tune in the station you want to preset.
• See “Tuning in a Station” above.
TUNING
FM MODE
MHz
2
Press SET k.
3
Press PRESET – / + ; to select a preset
number.
4
Press SET k again.
The tuned station in step 1 is stored in the preset number selected
in step 3.
• Storing a new station on a used number erases the previously
stored one.
When you unplug the AC power cord or if a
power failure occurs
The preset stations will be erased in a few days. If this happens,
preset the stations again.
Tuning in a Preset Station
1
Press FM/AM u.
The unit automatically turns on and tunes in the
previously tuned station (either FM or AM). The
Powered Rolling Panel automatically opens.
• Each time you press the button, the band
alternates between FM and AM.
2
Select a preset number.
On the unit:On the unit:
Press PRESET – / + ;.
On the remote control:On the remote control:
Press the number buttons &.
For preset number 5, press 5.
For preset number 15, press +10, then 5.
For preset number 20, press +10, then 10.
For preset number 25, press +10, +10, then
5.
SET
SEA CONTROL
PRESET
PREV
NEXT
SET
SEA CONTROL
FM AM
/
PRESET
PREV
NEXT
FM AM
/
Listening to FM and AM BroadcastsListening to FM and AM Broadcasts
CENTER MODE
DELAY TIME
PRO LOGIC 3 STEREO TEST TONE
CENTER
LEVEL
REAR
LEVEL
BALANCE
+
+
–
–
RL
EN6-17;MX-J777V/PM6 7/8/99, 9:16 AM17