Filter
Top Products
– 12 –
Listening to FM and AM (LW/MW) Broadcasts
Tuning in a Station
1
Press FM/AM.
The unit automatically turns on and tunes in
the previously tuned station (either FM or
AM — LW/MW). The Powered Rolling
Panel automatically opens.
• Each time you press the button, the band alternates
between FM and AM (LW/MW).
2
Start searching for stations.
On the unit:
Press and hold TUNING – / + for
more than 1 second.
On the remote control:
Press and hold 1 / 4 or
¢ / ¡ for more than 1 second.
The unit starts searching for stations and
stops when a station of sufficient signal
strength is tuned in. If a program is broadcast in stereo,
the STEREO indicator lights up.
To stop during searching, press TUNING – / + (or
1 / 4, ¢ / ¡).
When you press TUNING – / + (or 1 / 4,
¢ / ¡) briefly and repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is hard to receive or noisy,
press FM MODE on the remote control so that the MONO
indicator lights up on the display. Reception improves.
To restore the stereo effect, press FM MODE
again so that the MONO indicator goes off.
In this stereo mode, you can hear stereo sounds
when a program is broadcast in stereo.
Presetting Stations
You can preset 30 FM and 15 AM (LW/MW) stations.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
On the unit ONLY:
1
Tune in the station you want to preset.
• See “Tuning in a Station.”
2
Press SET.
3
Press PRESET – / + to select a
preset number.
4
Press SET again.
The tuned station in step 1 is stored in the preset number
selected in step 3.
• Storing a new station on a used number erases the
previously stored one.
When you unplug the AC power cord or if a power
failure occurs
The preset stations will be erased in a few days. If this happens,
preset the stations again.
Tuning in a Preset Station
1
Press FM/AM.
The unit automatically turns on and tunes in
the previously tuned station (either FM or
AM — LW/MW). The Powered Rolling
Panel automatically opens.
• Each time you press the button, the band
alternates between FM and AM (LW/MW).
2
Select a preset number.
On the unit:
Press PRESET – / +.
On the remote control:
Press the number buttons.
For preset number 5, press 5.
For preset number 15, press +10 then 5.
For preset number 20, press +10, then 10.
For preset number 25, press +10, +10,
then 5.
For preset number 30, press +10, +10,
then 10.
MHz
EN01-14.MXJ500,etc[B]/f 00.1.10, 2:09 PM12