JVC CA-MXGA8V Stereo System User Manual


 
– 31 –
English
Using Recording Timer
With Recording Timer, you can make a tape of a radio
broadcast automatically. You can set the timer whether the
system is on or off.
How Recording Timer works
The unit automatically turns on, tunes into the specified
station, sets the volume level to “VOL MIN,” and starts
recording when the on-time comes (the indicator flashes
just before the on-time, and continues flashing while the
timer is operating). Then, when the off-time comes (“OFF”
appears just before the off-time), the unit automatically turns
off (on standby).
The timer setting remains in memory until you change it.
There is a time limit in doing the following steps. If the
setting is cancelled before you finish, start from step 1
again.
To correct a mis-entry while setting the timer, press
CANCEL/DEMO.
On the unit ONLY:
1
Put a recordable cassette into deck B.
2
Press CLOCK/TIMER repeatedly
until “REC” appears on the
display.
The REC (Recording Timer) indicator also
starts flashing on the display.
Each time you press the button, the timer setting modes
change as follows:
3
Press CLOCK/TIMER again.
“ON TIME” appears for 2 seconds, then the
unit enters on-time setting mode.
4
Set the on-time you want the
unit to turn on at.
1) Turn 4/¢ to set the hour,
then press SET/DISPLAY.
2) Turn 4/¢ to set the
minute, then press SET/
DISPLAY.
“OFF TIME” appears for 2
seconds, then the unit enters off-
time setting mode.
5
Set the off-time you want the unit to turn off
(on standby) at.
1) Turn 4/¢ to set the hour, then press
SET/DISPLAY.
2) Turn 4/¢ to set the minute, then press
SET/DISPLAY.
The unit enters preset station selecting mode.
6
Select the preset station.
1) Turn 4/¢ to select the band (“TUNER FM” or
“TUNER AM”), then press SET/DISPLAY.
2) Turn 4/¢ to select a preset channel number, then
press SET/DISPLAY.
The REC (Recording Timer) indicator stops flashing
and remains lit. The settings you have done are shown
on the display in sequence.
7
Press STANDBY/ON to
turn off the unit (on standby)
if necessary.
If you want to listen to another source while recording
Press REC START/STOP or 7 to stop recording. Without
stopping it, you cannot change the source.
Even if you unplug the AC power cord or if a power failure
occurs
Once you set the timer, the timer setting may remain stored in
memory in a few days. In this case, check whether the timer
setting still remains or not.
DAILY
ON TIME
ON TIME
REC
Cancelled
Clock
setting
(See page 10.)
Continued
EN24-35.CA-MXGA9V/8V/7V 7/4/03, 3:30 PM31