Filter
Top Products
– 13 –
English
Playing Back Discs
This unit has been designed to playback the following CDs:
Audio CD, Video CD, CD-R, and CD-RW.
Continued use of irregular shape discs (heart-shape,
octagonal, etc.) can damage the unit.
When playing a CD-R or CD-RW
User-edited CD-Rs (Recordable) and CD-RWs
(Rewritable) can be played back only if they are already
“finalized.”
• You can play back your original CD-Rs or CD-RWs
recorded in music CD format. (However, they may not
be played back depending on their characteristics or
recording conditions.)
• Before playing back CD-Rs or CD-RWs, read their
instructions or cautions carefully.
• Some CD-Rs or CD-RWs may not be played back on
this unit because of their disc characteristics, damage or
stain on them, or if the player’s lens is dirty.
• CD-RWs may require a longer readout time. (This is
caused by the fact that the reflectance of CD-RWs is
lower than for regular CDs.)
Loading Discs
Whenever you press 0, the source automatically
changes to CD.
1
Press 0.
The unit automatically turns on and the
carrousel comes out.
2
Place one or two discs correctly on the front
slots of the carrousel, with its label side up.
• When using a CD single (8 cm), place it on the inner
circle of the disc tray.
3
If you wish to load a third disc,
press DISC CHANGE on the unit
or DISC SKIP on the remote
control.
The carrousel rotates by 120˚.
4
Press 0 again.
The carrousel closes.
About the disc indicators
Each disc indicator corresponds to the disc tray of the same number.
• The disc marker lights up for the disc number you have selected.
• The disc indicator rotates while the corresponding disc is being
played.
• The disc indicator goes off when the unit has detected that there is
no disc on the corresponding disc tray.
Playing Back the Entire Discs — Continuous
Play
You can play discs continuously.
1
Load discs.
2
Press one of the disc number
buttons (CD1, CD2 or CD3)
for the disc you want to play.
CD play starts from the first track of
the selected disc.
• Pressing CD 6 instead of the disc number buttons
starts playing back if a disc is on the tray.
When you turn on the unit, ALL DISC indicator lights up on
the display automatically. If you do not want all the discs to
play back, select 1 DISC by pressing REPEAT.
ALL DISC: Plays all loaded disc.
1 DISC: Plays back one disc.
To stop during play, press 7.
To remove the disc, press 0.
REPEAT ALL DISC REPEAT 1 DISC
REPEAT 1
1 DISC
ALL DISC
CORRECT
INCORRECT
Disc number
Disc indicator
DISC SKIP
Disc marker
DISC CHANGE
Track number
Elapsed playing time
Track number of the currently playing disc is
flashing. (Track numbers exceeding 16 are
not displayed.)
EN13-20.CA-MXG65V&68V[US]_f 01.5.17, 5:08 PM13