JVC AX-UXG6 Speaker System User Manual


 
9
Connecting Other Equipments
You can connect the following equipments to the system:
Audio equipment — used only as an analog playback
device.
Audio equipment with an optical digital input terminal
— used as a digital recording device.
When you connect and use these equipments, refer also to
the manuals supplied with them.
To connect audio equipment without a digital
output terminal
Connect the audio output jacks on the other equipment and
the ANALOG IN jacks, using an audio cable (not supplied).
Be sure that the plugs of the audio cables and the jacks on
the rear panel of the unit are color coded: White plugs and
jacks are for left audio signals, and red ones for right audio
signals.
DO NOT connect other equipment while the
power is on.
DO NOT plug in any equipment until all
connections are complete.
By using audio cable (not supplied), connect
between the audio output jacks on the other
equipment and the ANALOG IN jacks.
(AC wall outlet)
To ANALOG IN
To DIGITAL OUT
To audio output
XT-UXG6R
To optical digital input
Protective Plug
Before connecting the other equipment,
remove the protective plug from the terminal.
Continued
(AC wall outlet)
To ANALOG IN
XT-UXG6R
To audio output
on the other equipment
To connect audio equipment with an optical digital
input terminal
By using both an optical digital cable (not supplied) and an
audio cable (not supplied), connect:
Between the optical digital input terminal on the other
equipment and the optical digital output terminal on XT-
UXG6R.
Between the audio output jacks on the other equipment
and the ANALOG IN jacks.
NOW, you can plug in the system and other connected
equipment FINALLY!
When connecting the AC power cord into a wall outlet, the
system switches to standby mode with STANDBY/ON lamp
lit red.
EN01-13.UX-G6R[B]/5 99.11.30, 16:069