Filter
Top Products
11
English
Three ways to select a station
o Press the TUNING DOWN or TUNING UP button repeatedly to move from frequency to frequency
until you find the one you want. (Manual Tuning).
OR
o Press and hold the TUNING DOWN or TUNING UP button for a few seconds, the frequency starts
changing on the display. When a station is tuned in, the frequency stops changing. (Auto Tuning).
OR
o Possible only after presetting stations.
Press once and release the 4 P. DOWN or ¢ P. UP button to go to the next preset station, or hold
the 4 P. DOWN or ¢ P. UP button to cycle through the preset stations: release the button when
the preset station you want shows on the display.
You can also use the Remote Control to tune in preset channels:
1. Press the FM/AM button so that you can receive the most recent station tuned in.
2. Select the station by entering the preset number in the number keys of the Remote Control.
• Example: for channel 5, press 5. For channel 15, press +10 then 5. For channel 20, press +10,
then 10. For channel 30, press +10 twice then 10.
• After you have selected the preset number and the number is displayed, the broadcast frequency
of the selected channel is displayed.
Presetting Stations
You can preset up to 30 FM stations and up to 15 AM stations for the preset numbers.
Note: In some cases, test frequencies have been already memorized for the tuner since the factory
examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations
you want into memory by following the presetting method.
1. Select a band by pressing either the FM/AM button.
2. Press the TUNING DOWN or TUNING UP button to tune into a
station.
3. Setting the preset number by pressing the number keys on the
Remote Control continuously.
For preset numbers 1 to 10:
Press the number key for the preset number you want to set.
For preset numbers 11 to 20:
Press the 1 to 10 buttons after pressing the +10 button.
For preset numbers 21 to 30:
Press the 1 to 10 buttons after pressing the +10 button twice.
The preset number appears in the display after you have pressed the number keys. If the key is pressed
continuously, the preset number display blinks. Release the button after the number starts to blink.
This completes the preset setting.
4. Repeat steps 1 - 3 for each station you want to store in memory
with a preset number.
CAUTION: If the Unit is unplugged or if a power failure occurs, the preset
stations will be erased after a few days. If this happens, preset the
station again.
To Change the FM Reception Mode
When an FM stereo broadcast is hard to receive or noisy, press the FM MODE button on the Remote
Control so that the “MONO” indicator lights up in the display. Reception improves, but there is no stereo
effect.
To restore the stereo effect, press the FM MODE button on the Remote Control so that the “MONO”
indicator goes off. In this stereo mode, the “ST” indicator lights up and you can hear stereo effects, when
a program is broadcast in stereo.
TUNING
UP
TUNING
DOWN
P. UPP. DOWN
CD
TAPE
AUX
FM
/AM
1
23
456
7
8
9
10
10
CLOCK TIMER PTY/EON
DISPLAY MODE
SET
– SELECT +
1
2
3
FM/AM
or
FM MODE
TUNING
UP
TUNING
DOWN
CA-D351/451TR[E]/EN 97.4.16, 9:39 AM11