Filter
Top Products
17
Listening to FM Broadcasts
Basic Operations
Buttons
Operations
On the unit On the remote
Selects FM as the source.
When an FM program is broadcasted in stereo, ST (stereo)
lights up on the display (only when the reception is good).
Press: Changes the frequency.
Hold down and release: The unit starts searching for stations
and stops when a station of sufficient signal strength is found.
• To stop searching, press again.
—
Tunes in to a preset station: Press repeatedly to select a preset
station number. (For presetting stations, see page 18.)
—
Changes the FM reception mode: When an FM stereo
broadcast is hard to receive or noisy, press to improve
reception. MONO (monaural) lights up on the display.
Reception will improve though the stereo effect is lost.
• To restore the stereo effect, press again.
AM band is not received with this unit.
FM
AUDIO IN
NX-PN10[UW].BOOK Page 17 Thursday, May 20, 2010 8:46 AM