Filter
Top Products
6
English
To assemble and connect the AM loop antenna
To assemble the AM loop antenna
To connect the AM loop antenna
• If the AM loop antenna wire or speaker cords are covered
with vinyl, remove the vinyl to expose the tip of the
antenna by twisting the vinyl.
• Make sure the antenna conductors do not touch any other
terminals, connecting cords and power cord. Also keep the
antennas away from metallic parts of the System,
connecting cords, and the AC power cord. This could cause
poor reception.
To connect the speaker cords
Connect the right speaker to the R terminals, and the left
speaker to the L terminals.
When connecting the speaker cords, match the polarity of
the speaker terminals: gray cord (+) to red (+), and gray cord
with black stripe (–) to black (–).
Changing the Scanning Mode
This System supports progressive scanning.
If you connect a progressive TV through the COMPONENT
jacks, you can enjoy a high quality picture from the built-in
DVD player by selecting progressive mode.
• DO NOT connect more than one speaker to
each terminal.
• DO NOT allow the conductor of the speaker
cords to be in touch with the metallic parts of
the System.
1 Hold
3 Release
2 Insert
1 Hold 2 Insert 3 Release
PROGRE
(Progressive)
Progressive scanning.
For a progressive TV. The
PROGRESSIVE indicator lights.
INTER
(Interlaced)
Interlaced scanning.
For a conventional TV.
Remote
ONLY
PROGRE
INTER
(at the same time)
FS-GD7[C]_EN.book Page 6 Thursday, March 10,2005 9:43 AM