Filter
Top Products
29
English
Basic Setting Items
On the following pages, you can adjust the items listed below:
• You can adjust only the items applicable to the current sound
mode.
• If Analog Direct is in use, you cannot make any sound
adjustments.
Items To do See page
DIGITAL EQ Adjust equalizer pattern. 30
SUBWFR LVL Adjust the subwoofer output level. 30
FRONT L LVL Adjust the left front speaker output
level. 30
FRONT R LVL Adjust the right front speaker output
level. 30
CENTER LVL Adjust the center speaker output
level. 30
SURR L LVL Adjust the left surround speaker
output level. 30
SURR R LVL Adjust the right surround speaker
output level. 30
SBACK LVL Adjust the surround back speaker
output level. 30
EFFECT*
1
Adjust the DAP effect level. 31
ROOMSIZE*
1
Select the room size for your virtual
listening room. 31
LIVENESS*
1
Select the liveness level for your
virtual listening room. 31
CTR TONE Make the center tone soft or sharp. 31
PANORAMA*
2
Add “wraparound” sound effect with
side-wall image. 31
CNTR WIDTH*
2
Adjust the center channel localization
between the center speaker and the
left/right front speakers. 31
DIMENSION*
2
Adjust sound localization position. 31
CNTR GAIN*
3
Adjust sound localization of the
center channel. 31
Notes:
*
1
Adjustable when the DAP mode is in use.
*
2
Adjustable when Pro Logic II Music is in use.
*
3
Adjustable when Neo:6 Music is in use.
VOLUME
LINEAR PCM
L
SUBWFR
R
ANALOG
SPEAKERS 1
VOLUME
LINEAR PCM
L
SUBWFR
R
ANALOG
SPEAKERS 1
VOLUME
LINEAR PCM
L
SUBWFR
R
ANALOG
SPEAKERS 1
VOLUME
LINEAR PCM
L
SUBWFR
R
ANALOG
SPEAKERS 1
RX-7032V
AUDIO/VIDEO CONTROL RECEIVER
Basic Procedure
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
Ex. When adjusting the subwoofer level to “–3.”
1. Press ADJUST.
The last selected item appears on the display.
2. Turn MULTI JOG until an item you want
appears on the display.
• In this example, select “SUBWFR LVL.” For available items,
see the list to the left.
3. Press in MULTI JOG (PUSH SET).
The current setting (or level) for the selected item appears on the
display.
4. Turn MULTI JOG to select a setting you want or
to make an adjustment as you like.
5. Press EXIT.
6. Repeat steps 2 to 5 to set other items if necessary.
7. Press EXIT.
The source indication resumes on the display.
Adjusting Sound
You can make sound adjustment to your preference after completing basic setting.
29-31_7032[US]f.pm6 03.3.13, 4:31 PM29