Filter
Top Products
5
Figure 5
Removing the grille using a paper clip
REMOVING THE GRILLE
If the grille is already installed, remove it by using a bent paper clip or the tip of a
corkscrew and pulling it away from the frame. See figure 5
4. Drill pilot holes into the mounting
surface.
5. If the mounting holes line up with a
stud, use galvanized screws to
secure the bracket to the wall.
6. If the mounting holes do not line up
with a stud, secure the bracket to the
wall using anchors designed to
support the weight of the speaker.
7. Strip 1/4" of insulation from the end of
each wire.
8. Tightly twist the end of each wire
until no frayed ends remain.
9. Attach the speaker wires to the
speaker terminal connectors.
Connect the negative output from the
amplifier to the black terminal.
Connect the positive output from the
amplifier to the red terminal.
10. Remove the bracket knobs from the
speaker.
11. Slide the speaker into the mounting
bracket.
12. Insert the knob through the bracket
and into the threaded insert in the
cabinet
13. Secure the speaker in place by
tightening the bracket knobs.
14. Repeat this procedure for the
next speaker.
DS00386ATW_LSO-5_6_7_8.qxp 11/18/04 7:22 PM Page 5