Filter
Top Products
4
PACKAGE CONTENTS
■ AB50-X2 x 1
■ Removable AC power cord x 1
■ Snap and lock removable speaker connectors x 4
■ Self adhesive rubber feet x 4
PREPARING FOR INSTALLATION
The local TV cables, Multizone Receiver cables and
Speaker cables must reach the proposed location of
the AB50-X2. Mark the cables with Wire labels,
describing where the cables originate from, rather
than where they will terminate. Locate a local un-
switched AC outlet to be used to power the AB50-X2.
Tools Required
■ 1/8" Slotted screwdriver
■ 1/4" Slotted screwdriver
■ No.2 Phillips screwdriver
■ Wire stripper
■ Wire labels
INSTALLATION
1. Select an appropriate location for the AB50-X2.
2. Run all necessary wiring to the AB50-X2. Label the
wires for future reference.
3. Strip 1/4" of insulation from the end of each wire.
Tightly twist the end of each wire until no frayed
ends remain.
4. Locate the Snap and Lock connectors and remove
them if they are plugged in.
5. Use a small flathead screwdriver or your thumb to
raise the locking tabs, exposing the holes on the
connector.