Filter
Top Products
SB-F-F1502/10W3v3_INSTR_SKU#011251
SB-F-F1502/10W3v3_INSTR_SKU#011251
STEALTHBOX WALL
REAR SEAT BRACKET
THREADED INSERT
LOCK WASHER
FLAT WASHER
SOCKET CUP SET SCREW
HEX NUT
CONGRATULATIONS
You have completed the installation for this model!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
STEP 6
Place a supplied flat washer, lock washer and then hex nut
onto each socket cup set screw and secure.
STEP 5
Guide the two socket cup set screws through the existing
holes that are located on the rear seat brackets.
STEP 4
Run speaker wire from the amplifier’s location to the
Stealthbox
®
location and check for proper operation of
the woofer.
Page 3 • JL Audio, Inc 2007
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU#011251-01-24-200
JLA-SKU#011251-01-24-200
8
8 • Printed in USA • ©2007 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902
#6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign
patents pending. For more detailed information please visit us online at www.jlaudio.com.
(954) 443-1100
www.jlaudio.com
10369 NORTH COMMERCE PARKWAY • MIRAMAR, FLORIDA • 33025 • USA
INCLUDED HARDWARE
(2)
(2)
3/8” -16 x 2-1/4” Socket Cup Set Screw
3/8” -16 x 2-1/4” Socket Cup Set Screw
(2)
(2)
3/8” Flat Washer
3/8” Flat Washer
(2)
(2)
3/8” Split Lock Washer
3/8” Split Lock Washer
(2)
(2)
3/8” -16 Hex Nut
3/8” -16 Hex Nut
SPECIFICATIONS
Enclosure Type:
Bass Reflex (ported)
Bass Reflex (ported)
Driver Type:
10W3v3-4
10W3v3-4
Nominal Impedance:
4 ohms mono
4 ohms mono
Continuous Power Handling:
500 Watts
500 Watts
P O W E R R E C O M M E N D A T I O N
POWER RECOMMENDATION
JL Audio recommends using a high quality amplifier such as the JL Audio 500/1v2.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 500/1v2
when being used to power your Stealthbox
®
.
+12VDC Ground Remote Preamp Output Section
Infrasonic Filter
“Q” Center Freq. Boost (dB)
Amp LP Filter
Advanced
Bass
Control
Amplifier Input Section
Subwoofer Output
MONO OUTPUT ONLY
Left Output Right Output Left Ch. Right Ch.Filter Freq. (Hz) Filter Freq. (Hz)Infrasonic Freq. (Hz) Remote Bass Port
Full Range
|
Amp Filter
|
Out Filter
Output Mode Filter Slope Mode
Mode
|
Slope
Input Voltage Input Sens. Signal Sensing
12dB
|
24dB
Filter Mode
LP
|
HP
Bass EQ
Off
|
On
Off
|
12dB
|
24dB Low
|
High Off
|
OnOff
|
On
40
45
55
65
80
100
200 15
18
22
30
45
55
60 40
45
55
65
80
100
200
0.5
0.7
1.1
1.6
2.7
4.3 20
25
30
40
60
75
80 0
+4
+10
+13
+15
500/1v2
Monoblock Subwoofer Amplifier
The JL Audio 500/1v2 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.
MID/HIGH FREQUENCY DRIVER FITMENT
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location:
5” x 7” / Front Doors
5” x 7” / Front Doors
Fits JL Audio Models:
TR570-CXi, C5-570, C5-570x & ZR570-CS
TR570-CXi, C5-570, C5-570x & ZR570-CS
i
i
Rear Speaker Size / Location:
5” x 7” / Rear Door
5” x 7” / Rear Door
Fits JL Audio Models:
TR570-CXi, C5-570, C5-570x & ZR570-CS
TR570-CXi, C5-570, C5-570x & ZR570-CS
i
i