Jensen JTA-475 Turntable User Manual


 
12
from entering the CD mechanism.
Never place more than one CD in the CD tray. If two discs are loaded at the same
time, the CD mechanism may jam and / or the discs themselves may be damaged.
TO BEGIN CD PLAYBACK
After you have loaded the CD in the player:
1.) Press the PLAY/PAUSE button to begin playback. The player will begin
playback from Track 1 on the disc.
2.) Press and hold the VOLUME+/- buttons to adjust volume level as desired.
3.) To temporarily stop playback, press the PLAY/PAUSE button again. The disc
continues to spin, but no sound is heard. Press the PLAY/PAUSE button once
more to cancel pause and resume playback.
4.) To stop playback before the end of a disc, press the STOP button.
IMPORTANT!!
If the disc is smudged or scratched it may skip or stop completely. This does not indicate
a problem with the player. If this occurs, try playing another disc. If that disc plays
properly, you may assume that the first disc is damaged and unplayable.
or SKIP/SEARCH Buttons
To skip forward or backward during playback, press the or SKIP/SEARCH
buttons repeatedly until the desired track number appears on the display. Playback will
begin on the desired track.
To search for a particular passage on a track during playback, press and hold the
or SKIP/SEARCH buttons. The player will search rapidly forward or backward.
Release the buttons when you reach the desired point on the track and normal speed
playback will resume at that point.
PROGRAMMED CD PLAYBACK
The CD player can be programmed to play any sequence of up to 20 tracks.
1.) Press the STOP button before starting the programming.
2.) After the disc loads, press the PROGRAM button. The “PROG.” indicator will appear
flashing on the display. The display shows program track “01” and then changes to
flashing “00” to prompt you enter the CD track to be programmed.
3.) Select the desired track number by pressing the or SKIP/SEARCH
buttons.
4.) Press PROGRAM button to confirm the track number. Program track advanced to
“02” and then display shows “00” and flashing to prompt you enter another CD track.
5.) Repeat above steps 3-4 until you have stored up to 20 tracks in the program memory.
6.) Press the PLAY/PAUSE button to begin programmed playback. Playback will
(up to total of 20) have been played.