Jensen JSIR900B Radio User Manual


 
128-7369
6 of 12
1.
Turn the Boom Box upside down to access
the battery compartment.
2.
Push the battery cover latches forward and flip
up the battery compartment cover to the open
position.
3.
Insert eight (8) D-Cell batteries observing
battery polarity as shown; then close the cover.
3. Installing the Receiver in the JSIR900B
Install the Receiver as follows:
1.Press the EJECT button at the top of the JSIR900B
to open the spring-loaded cover. Carefully line up
the Receiver rear spine grooves with the Boom Box
guide spines; lower the Receiver into the Boom Box.
-6-
2.Cabling Interconnections
You can begin to enjoy Sirius® Satellite Radio
as soon as the Receiver and Boom Box Kit
installation are complete. Set up your Jensen
JSIR900B by following the interconnect diagram.
NOTE: The batteries are bypassed automatically
whenever the supplied AC Adapter is
plugged into the DC 12V jack on the back
panel.
BATTERY
COMPARTMENT
(COVER REMOVED)
NEGATIVE
POSITIVE
NEGATIVE
POSITIVE
1.Battery Installation
Your Boom Box can operate independently of AC
power by installing 8 D-Cell batteries as follows:
BATTERY
COMPARTMENT
COVER
BOTTOM OF
BOOM BOX
COVER LATCHES
RECEIVER
REAR VIEW
RECEIVER
REAR SPINE
GROOVES
AUDIO OX
JSIR900B
GUIDE
SPINES
PNP COVER
RECEIVER
COMPARTMENT
CONNECTOR
GUIDE PIN
20-PIN
SYSTEM
CONNECTOR
EJECT BUTTON
SAT
CONNECTOR