Jensen JMC-1100 Turntable User Manual


 
CD PROGRAMMING
Up to 60 tacks can be programmed to be programmed to be played in any required order from
one CD or all CDs in the CD changer.
1. Set in CD mode and press the “STOP
button.
2. Press the MEM/CLK-ADJ button
3. Press the “
” to select the desired disc.
4. Press SKIP DOWN
or UP
button to select the desired track.
5. Press the “MEM/CLK-ADJ” button again to store the track in memory.
6. Repeat steps 2 to 5 to enter additional program
7. Press “PLAY/PAUSE” button to start playback in order.
8. Press “STOP
” button to stop playback and press it twice to clear all programmed tracks.
LISTING TO TAPE
GENERAL OPERATION
STOP / EJECT KEY
Press to stop all deck operation. Press again to open the cassette
door.
FAST FORWARD KEY
Press to start rapid tape winding in either forward or reveres
& REWIND KEY direction. Press stop / eject key when the cassette spools stop
turning.
PLAY KEY
Press to start playing tape.
PAUSE KEY
Press to stop tape operation temporarily. Press again to resume.
RECORD KEY
Press together with play key to start tape recording.
(DECK 1 ONLY)
PLAYBACK
Press “TAPE” button to active tape function
Put in the cassette tape.
Press PLAY key to active playback
Adjust the volume control to the desired level.
Use PAUSE key when you want to stop playback temporarily.
Press STOP / EJECT key when finished.
RECORDING
This cassette recorder features an Automatic Recording Volume Level Control System that
prevents overloaded or distorted recordings. You can change the volume level as often as you
like during the recording process. It will not have any effect on the volume level of the recording
itself.
Insert a good quality blank tape into DECK A with the exposed tape facing down and the full reel
on the left side. Close DECK A door.
14