Filter
Top Products
7
2. Plug one end of an appropriate audio cable (not included) into the AUX IN Jack of this unit and the other
end to the line out or headphone jack of your digital audio player.
3. Start playing your digital audio player and gradually increase the volume output (if necessary) until a clear,
undistorted sound is heard from the speakers of this unit.
4. Adjust the VOLUME CONTROL until you reach a comfortable listening level.
5. To stop auxiliary input function, simply remove the line in cable from the AUX IN JACK.
CD OPERATION
NOTE: This unit not only plays commercial compact discs but also self-complied CD-RW discs.
•
Because of non-standardized format definition/production of CD-R/RW, playback quality &
performance are not guaranteed.
• Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions such as
PC performance, writing software, media properties etc.
• Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a malfunction.
PLAY MODE
1. Slide the FUNCTION SWITCH to the “CD” position.
2. Open the CD DOOR, load a CD with the label side facing upward and then close the CD door.
3. Disc information (total number of tracks) will appear on the LED DISPLAY.
4. Press PLAY/PAUSE BUTTON to start playing the CD. The play/pause indicator on the LED
DISPLAY will light steadily.
5. Adjust the VOLUME CONTROL to the desired volume level.
6. Press STOP BUTTON to stop playing.
7. To turn off the CD player, slide the FUNCTION SWITCH to “AUX (OFF)”.
NOTE: If skipping occurs during CD play, try turning the volume down.
Do not open the CD DOOR when a CD is playing.
REPEAT MODE
Repeat 1
When the REPEAT BUTTON is pressed once, the repeat indicator on the LED DISPLAY will light and blink
continuously. The current track will be repeated until it is interrupted.
Repeat All
When the REPEAT BUTTON is pressed twice, the repeat indicator will light steadily. The whole disc will be
played continuously.
To Cancel Repeat Function: Press the REPEAT BUTTON until the repeat indicator is off.
SKIP AND SEARCH MODE
1. During Play or Pause mode, tap the FORWARD (FF) "!" or REVERSE (REV) """ BUTTON to go to
the next track or go back to the beginning of the track.
2. During play mode or Pause mode, press and hold the FORWARD (FF) "!" or REVERSE (REV) """
BUTTON to search within the track with audible high speed forward or backward playback.
PROGRAM PLAY MODE
This function allows music tracks to be played in a programmed sequence.
NOTE: Program can only be set in STOP mode.
1. Press the PROGRAM BUTTON once. “0” will flash in the LED DISPLAY.
2. Press the FORWARD (FF) "!" or REVERSE (REV) """ BUTTON to select the track to be
programmed. In this example, track 5 is selected.
3. Press the PROGRAM BUTTON again to store selection. The LED DISPLAY will go back to “0” and blink
to prompt for the next input.
4. You may repeat steps #2 to #3
to program as many as 20 tracks. If you attempt to program more than
20 tracks, “ - - “ will blink in the LED DISPLAY.
5. Press PLAY BUTTON to complete and start program play. Press STOP BUTTON to stop.