Filter
Top Products
SS6C, SS6DT, SS8C
EXISTING CONSTRUCTION
Remove the grille from the
speaker frame by pulling on the
paper tab. If the tab is missing,
to avoid scratching the grille or
baffle you may unfold a paper
clip, insert the straight end
through one of the holes in the
grille, and gently pull up.
1/2"
1/2"
1/2"
Cut the drywall. N
ote:
Always
allow at least one-half inch
between a wall stud and the
speaker cutout or the locking
tabs will not be able to swivel
into place.
Connect the speaker wires
to the speaker.
Place the frame assembly
in the wall.
Screw down each of the three
Phillips-head screws. The locking
tabs will swivel into place and
secure the unit to the rear surface
of the drywall.
Replace the metal grille.
Determine the correct speaker
location.
N
ote:
Remove the
inner template, which is the
paint shield, at the perforation.
Use the outer template when
cutting the drywall.
The SS6C and SS8C speakers
feature unique
swivel mounts
for the tweeters that enable
you to aim the very directional
high frequencies
toward the
listening position, at ear-level
height. Before installing the
speaker grille, gently press on
the outer edge of the tweeter
mount to adjust the position
of the tweeter. The tweeter
will not swivel more than 15
degrees in any direction; do
not attempt to force it to move
further. You may also rotate
the tweeter to correctly orient
the JBL logo as desired.
6
Performance Specialist OM 3/3/06 4:54 PM Page 6