Filter
Top Products
6
Connect each speaker to
the corresponding speaker
t
erminals on your receiver
or amplifier.
If you are using a subwoofer,
follow the directions in that
owner’s guide to connect
and configure it.
Configure your receiver or
processor to reflect the cor-
r
ect number of speakers in
your system. If you have
added one SCSSAT300/200
speaker to a 5.1-channel
system, reconfigure it as
a 6.1 system. If you have
added two SCSSAT300/200
speakers to a 5.1-channel
system, reconfigure it as
a 7.1 system.
The SCSSAT300/200 should
be set to “Small.” If your
r
eceiver allows you to set
the crossover frequency
between the subwoofer and
the speakers, select
100Hz or
the setting that is the closest
frequency below it.
SYSTEM CONNECTION
– +
– +
– +
– +
– +
– +
– +
– +– +
Receiver
Subwoofer
Out
Left
Front
Left
Surround
– +
Right
Front
Right
Surround
Subwoofer
Center
Surround Back
Left
– +
Surround Back
Right
LFE In
Right Surround
Right Front
Left Surround
Left Front
Center
– +
Surround Back
Left
– +
– +
Surround Back
Right
SCS-SAT300/200 OM 5/24/06 12:41 PM Page 8