Filter
Top Products
OPERATION
MIN MAX
Subwoofer
Level
MIN MAX
Subwoofer
Level
Move the Master Power
switch (marked “Power” ¡)
to the “
•
” (On) position to use
the subwoofer. The
subwoofer will automatically
turn itself on or go into
standby (sleep) mode when
left in the standby mode
(“Auto/On” switch
™ in the
“Auto” position). When your
receiver or amplifier is off, or
is not sending program
material to the subwoofer,
the subwoofer will be in
standby mode. When the sub-
woofer senses an audio signal,
it will automatically turn itself
on. If the subwoofer does
not sense a signal after
approximately twenty minutes,
it will automatically go into
standby mode.
When the “Auto/On” switch
™ is switched to the “On”
position, the subwoofer will
remain on, whether or not
program material is playing.
If you will be away from
home for an extended period
of time, or if the subwoofer
will not be used, switch the
Master Power switch
¡ to
the Off position.
Volume
POWER
HIGH LEVEL
+ – – +
SUBWOOFER
LEVEL
OUT
IN
L R
LINE LEVEL IN
LFE
L
R
AUTO ON
MIN MAX
AC 120V~60Hz
250 Watts
3.15A/250V
TYPE T
£
¡
™
IMPORTANT: CONNECT STRIPED WIRE TO RED ( ) SPEAKER TERMINAL.
GREEN: ON
RED: STANDBY
+
AVIS : RISQUE DE CHOC ÉLECTRIQUE-NE PAS OUVRIR
WARNING: FOR CONTINUED
PROTECTION AGAINST RISK
OF FIRE, REPLACE ONLY WITH
SAME TYPE 3.15A, 250 VOLT FUSE
AVERTISSEMENT: UTILISEZ UN
FUSIBLE DE RECHANGE DE MEME
TYPE 3.15A, 250V
A Harman International Company
JBL, Incorporated
This area is designed to become quite warm
during normal operation
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
AVERTISSEMENT: POUR PRÉVENIR LES RISQUES D'INCENDIE
OU DE CHOC ÉLECTRIQUE, ÉVITER D'EXPOSER CET APPAREIL
A LA PLUIE OU A L'HUMIDITÉ.
Volume can be adjusted
using the Subwoofer Level
Control £ (above), as shown
below.
SCS150SI/SCS160SI/SCS180.6S
6